Rust-Oleum NeverWet Industrial Liquid Repelling Treatment
Rust-Oleum NeverWet Industrial Liquid Repelling Treatment
Rust-Oleum NeverWet is a superhydrophobic coating system designed to create a protective barrier to repel water, ice, mud and other liquids. This revolutionary coating causes water to form nearly perfect spheres which roll off the surface keeping assets clean and dry. NeverWet can be used on metal, concrete, masonry, wood, vinyl and more. This product can be used indoors and out. NeverWet coating sprays on clear and dries to a flat light haze.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Industial NeverWet Repelling Treatment
- Efficiently coat large equipment
- More durable than NeverWet aerosols
- VOC compliant nationwide
- After base coat is applied, wait 45 minutes and apply top coat. NeverWet will repel water after 30 minutes. Wait 12 hours for optimal performance.
- Ideal applications include winterization of assets, mixing/blending equipment, concrete, conveyors, awnings, walls, and more.
Featured Video of NeverWet Industrial Liquid Repelling Treatment
How to Apply NeverWet Industrial Liquid Repelling Treatment?
Surface Preparation
Surfaces must be dry, clean and free of dirt, oil, grease, wax, dust, chalk, rust or any other contaminants that may prevent proper adhesion. Remove all loose or peeling paint. Plaster, concrete block, concrete and masonry surfaces must be cured. Remove all form release and curing agents.
Application
Mix basecoat thoroughly with a powered mixer or paint shaker. Stir often during use. Thoroughly shake topcoat before use. Remove lid with care. Apply only when air and surface temperatures are between 50-90°F (10-32°C) and the relative humidity is not greater than 85%. Dry times may be affected by extremely high or low relative humidity.
Base Coat - Spray apply a continuous wet film free from sags and runs. Wait 45 minutes.
Top Coat - Spray apply several light coats until a cloudy, slightly hazy film is evident. Water repellency will start after 30 minutes with optimum performance after 12 hours.
Properties of NeverWet Industrial Liquid Repelling Treatment
Properties | Base-Coat | Top-Coat |
---|---|---|
Brand | NeverWet | |
Manufacturer | Rust-Oleum | |
Weight | 3.78 Ltr | 3.78 Ltr |
Composition | Hydrocarbon Resin | NA |
Pigment Type | NA | Silicone Derived Proprietary Ingredients |
Solvents | Exempt Aromatic Solvents | Acetone |
Volatile Organic Compounds | 0 g/l | 0 g/l |
Recommended Dry Film Thickness (DFT) per Coat |
NA | NA |
Wet Film to Achieve DFT (unthinned material) |
Apply Apply material until a visual sag free film is evident |
Apply 2-4 light coats until a cloudy, slightly hazy film is evident |
Practical Coverage at Recommended DFT (assumes 15% material loss) |
200-300 sq.ft./gal | 200-300 sq.ft./gal |
Dry Times at 70°F (21°C) and 50% Relative Humidity |
45 minutes to Touch. 4 Hours to Handle. 15 minutes (with itself) to Re-Coat |
15 Minutes to Touch. 4 Hours to Handle. 1 minute (with itself) to Re-Coat |
Dry Heat Resistance | 230°F (140°C) | 230°F (140°C) |
Shelf Life | 2 years | 2 years |
Flash Point | 109°F (43°C) | -4°F (-20°C) |
Safety Information | For additional information, see MSDS | |
Technical Data Sheet | Click here |