Rust-Oleum Epoxyshield Concrete Floor Paint

Rust-Oleum Epoxy Shield Concrete Floor Paint is available in two colors armor and battle ship gray. This paints is formulated to offer protection to concrete floors from weather, ultra violet rays, hot tires and chemicals. You can use it to paint your garages, driveways, patios, walkways, basement, pool decks, carports, shop floors and more. This acrylic modified paint is not recommended for floors that are suffering from moisture problems or unsound previous coating.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of Concrete Floor Paint

• 1-Part Advanced Acrylic Technology.
• Hot Tire and Chemical Resistant.
• UV & Weather Resistant.
• Interior / Exterior Durability.
• Satin Finish.

NOTE:For best results, apply as per the instructions that are printed on tin.

How to Apply EpoxyShield Concrete Floor Paint

Surface Preparation

Allow new concrete to cure for a minimum of 28 days. Sweep away all loose dirt and debris. Remove any oil spots, grease or spills and wash the floor with a suitable detergent or degreasing solution and rinse. Then etch the floor using the Rust-Oleum Concrete Etch.

Previously Coated Floors : Make sure the floor is clean and dry. Use a wire brush to remove any loose or peeling paint or stain. If floor is sealed, the sealer will have to be removed by grinding or shot blasting. To ensure proper adhesion, scuff sand the entire surface.

Application

Apply only when air, material, and surface temperatures are between 60-85°F (15-29°C) and the surface temperature is at least 5°F (3°C) above the dew point. The relative humidity should not be greater than 85%. Stir thoroughly. Cut in the perimeter of the floor along the wall, or other areas where a roller cannot reach, using a brush or edger before beginning roller application. Use a synthetic ½"" nap roller cover on a 9"" roller frame to apply an even coat of EpoxyShield Concrete Paint onto the surface. Limit the application to 4x4 foot (1.2x1.2m) sections at a time. If decorative chips are used, scatter the chips up and away from you so they land flat on the wet paint, then continue on to the next section. Note: Fresh paint can be applied over the loose chips lying outside the previously painted area. Maintain a wet edge to prevent lap marks and gloss differences. Make all final passes in the same direction to help ensure uniform appearance. Only one coat is necessary under most circumstances. Occasional touch-up may be required in areas subject to heavy traffic.

Properties of Epoxyshield Concrete Floor Paint