Rust-Oleum Automotive Wax & Tar Remover is manufactured to remove tar, grease, wax, silicone, and road film. It is suitable to use for metal, fiberglass, plastic and more. This chemical removes old wax build-up before reapplication of new wax and promote an even, mirror like finish. It is good use the product before sanding to prolong the life of sandpaper and again after sanding as a clean-up agent prior to applying top coats.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of the product:-
- Fast-acting wax & tar remover for metal, plastic and fiberglass.
- Removes old wax build-up, grease, silicone and road film.
- Promotes an even, mirror-like finish.
- Ideal for use before and after sanding.
How to Apply Rust-Oleum Wax And Tar Remover?
Application of Quart
Protect hands with solvent-resistant gloves and eyes with chemical splash goggles. Saturate a clean, lint-free cloth with Wax & Tar Remover. Thoroughly cover area to be cleaned. Apply to a small area (3’ x 3’) at a time. Allow to stand as long as possible without drying, normally 4 to 6 minutes. Wipe dry with a clean, lint-free white cloth. Turn cloth frequently to ensure a clean side contacts surface. Replace cloth as it becomes damp and soiled to prevent re-depositing of contaminants.
Application of Spray
Protect hands with solvent-resistant gloves and eyes with chemical splash goggles. Hold can in an upright position approximately 8-12" from surface with arrow on button pointed away from you. Apply a liberal coat and allow to stand for 1 minute and wipe dry with a clean lint-free cloth. Turn cloth frequently to ensure a clean side contacts surface. Replace cloth as necessary.
Properties of Rust-Olem Wax and Tar Remover
|Weight||946 ml||383 Grams|
|Composition||Ethoxylated Alcohols and Water||Aliphatic and Aromatic Hydrocarbons|
|Shelf Life||5 Years||5 Years|
|Flash Point||>200°F (93°C)||156°F (-104°C)|
|Technical Data Sheet||Click here||Click here|