Varathane One Step Stain and Polyurethane enables you to add stain and protection to the interior wooden surface in one step. This innovative polyurethane is available in semi-gloss finish. This can be used for wooden doors, paneling, furniture, trim, and cabinet etc. This Varathane product is oil-based but it is available in water-base as well. This is available in 8 unique wood stains such as cabernet, dark walnut, early american, red mahogany, traditional cherry, golden pecan, golden oak and provincial.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of One Step Stain and Poly
- Combination of wood stain and polyurethane in one.
- Perfect for interior wood finishing projects like furniture, trim, cabinets, doors & paneling.
- Efficient coverage – 175 square feet.
- Even color, no brush marks.
NOTE: Before you apply, prepare the surface by sanding in the direction of wood grains.
How to Apply Varathane One Step Stain & Polyurethane?
Remove any existing finishes with sandpaper or stripper. Prepare bare wood for product application by sanding in the direction of the grain. Begin with #120 grit sandpaper and progress through #150, #180 and #220 grits. Before staining, remove all sanding dust, dirt, grease or glue with a vacuum or clean rag dampened with mineral spirits.
Stir the contents thoroughly before use. Do not shake. Use adequate ventilation at all times. Apply only when air (ambient) temperature is between 55-90°F (13-32°C) and the relative humidity is below 85%. Apply using a good quality, natural bristle brush or applicator, brush in the direction of the grain until a uniform film has been achieved. To prevent brush marks, avoid excessive brushing. Additional coats can be applied with one hour dry time between coats. Lightly sand between coats with #320 grit sandpaper. Remove all sanding dust before applying additional coats.
Properties of Varathane One Step Stain & Polyurethane
|Resin Type||Oil Modified Urethane|
|Pigment Type||Micro Particle Organic Pigments|
|Solvents||Aromatic Petroleum Distillates|
|Recommended Dry Film
Thickness (DFT) Per Coat
|1.0 mils (25µ)|
at Recommended DFT
(assumes 15% material loss)
|Dry Times at 70-80°F (21-27°C)
and 50% Relative Humidity
|Dust Free in 1 Hour and Fully Dry in 4 Hours|
|Shelf Life||5 Years|
|Flash Point||106° F (41°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|