Rust-Oleum Universal Metallic Spray Paint is made to deliver the attractive metallic shine on almost all surface. This all surface spray paint acts as a paint and primer and offer durability. This aerosol spray paint has excellent resistance to rust, abrasion, fading, chipping and dulling. It is possible to paint 10-15 square feet of area with one cane. It get dried to touch in 30 minutes.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Universal Spray Paint
- Compatible with interior and exterior surfaces.
- Ideal to use over wood, metal, wicker, plastic and many other surface.
- Excellent coverage as one cane covers up 15 sq.ft.
- Resistant to fade, chip and rust.
NOTE: This is not recommended to use for galvanized metal.
Featured Video of Universal Metallic Spray Paint
How to Use Universal Metallic Spray
Appropriate Conditions to Spray
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90ºF (10-32ºC) and humidity is below 65% to ensure proper drying. Do not use on objects that may exceed 200ºF (93ºC) surface temperature. Do not apply to galvanized steel. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Prior to use, slide off the red safety clip from the trigger. Hold can upright 8-12” from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply two or more moderate coats at moderate speed to avoid drips and runs. Do not use near open flame.
Properties of Universal Metallic Spray Paint
|Resin Type||Modified Alkyd|
|Pigment Type||Varies with color|
|Solvents||Acetone, Ketone Blend|
|Recommended Dry Film Thickness
(DFT) Per Coat
|1.0-2.0 mils (25-50µ)|
|Practical Coverage at Recommended
DFT (assumes 15% material loss)
|10-15 sq. ft./can|
|Dry Times at 70-80°F (21-27°C)
and 50% Relative Humidity
|30 minutes to touch and re-coat within an hour or after 48|
|Shelf Life||5 years|
|Flash Point||156ºF (-104ºC)|
|Dry Heat Resistance||200ºF (94ºC)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|