Rust-Oleum Trim And Bumper Sponge Applicator Black Paint
Rust-Oleum Trim and Bumper Paint is available in sponge applicator which makes it easy to use. It renew and restore the look of faded OEM finishes found on vehicles. This automotive paint is suitable for applying on trim, bumper, plastic, rear view mirror, rub strips and more.
Features of Paint
- Ideal for metal and plastic
- Restores OEM black finishes
- Suitable for trim/moldings, bumpers, mirror covers, etc.
- Nationally VOC compliant.
NOTE: Read and follow the instructions that are printed on tin.
Featured Video of Rust-Oleum Trim And Bumper Paint
How to Apply Trim And Bumper Sponge Applicator Paint?
Ideal Conditions to use
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-80°F (10- 26°C) and humidity is below 85% to ensure proper drying. For best results, do not paint in direct sunlight.
Remove all dirt, wax, and grease from the surface with Rust-Oleum Wax And Tar Remover. Wash the area with a mild soap and water solution, fresh with fresh water, and dry with a clean cloth. Lightly sand uneven areas and remove all sanding dust.
Priming for Best Results
To improve adhesion, a Rust-Oleum Primer is recommended when rust is present on the surface to be painted. Recommended primers include 249321 Primer Sealer or any of the sandable primers (249419 Red, 252472 Light Gray, or 249415 Gray).
Use only with adequate ventilation. Without removing the cap, shake bottle for one minute. Recap and shake as needed during the painting process. Depress the sponge applicator tip in an inconspicuous area or on a piece of scrap material to start the paint flow. Apply paint using light pressure on the bottle. For best appearance, apply one coat of paint, let dry, and feather the edge. For even coverage, maintain a wet edge and with the sponge tip, smooth out any runs, drips, sags or excess paint. A foam brush may be used for hard to reach areas or to smooth out the paint finish. A second coat may be necessary for best coverage. Do not use near open flame.
Properties of Rust-Oleum Trim and Bumper Paint
|Resin Type||Modified Alkyd|
|Pigment Type||Carbon Black|
Recommended Dry Film
Thickness (DFT) Per Coat
|1.0-2.0 mils (25-50µ)|
at Recommended DFT
Dry Times at 70-80°F
(21-27°C) and 50% Relative Humidity
|20 minutes to touch and re-coat after 24 hours|
|Shelf Life||5 years|
|Flash Point||77°F (25°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|