Rust-Oleum Stops Rust Hammered Spray Paint is designed to paint old rusty metallic surfaces such as railings, wheel rims, furniture and more. You can paint it directly without sanding or priming. It is also suitable for non-metal surfaces like wood This fast drying unique hammered finish resists rust abrasion, fading, chipping and dulling. These qualities ensures that surface will remains attractive for long.
Features of Hammered Metal Spray Paint
- Sanding and priming is not required.
- Bond directly to rust.
- Hides flaws.
- Available in eye-catching colors.
NOTE:This is not recommended to galvanized metals.
How to Use Rust-Oleum Stops Rust Hammered Metal Spray Paint?
Appropriate Conditions to Use
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10- 32°C) and humidity is below 65% to ensure proper drying.Do not apply to surfaces, when heated, exceed 200°F (93°C). Do not apply to galvanized steel. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply two or more light coats a few minutes apart to avoid drips and runs. Do not use near open flame.
Properties of Rust-Oleum Stops Rust Hammered Metal Spray Paint
|Resin Type||Oil Modified Alkyd|
|Pigment Type||Varies with color|
|Solvents||Acetone Aromatic Hydrocarbons, Xylene|
Recommended Dry Film
Thickness (DFT) Per Coat
|1.0-2.0 mils (25-50µ)|
at Recommended DFT
|10-12 sq. ft./can|
|Dry Times at 70-80°F (21-27°C)
and 50% Relative Humidity
|15 minutes to touch and re-coat before 1 hour or after 24 hours|
|Dry Heat Resistance||200°F (93°C)|
|Shelf Life||5 years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|