Rust-Oleum Automotive Spray Paint for Plastic - Best for Plastic Surface
Product Code: 248649
Availability:Out of stock
Have a question?
Rust-Oleum Automotive Spray Paint for Plastic renews and invigorates plastic surfaces such as polypropylene, polystyrene resin, PVC, automotive and fiberglass. It is also good to paint chairs, tables and planters as it ideal for vinyl plastic. It is not required use primer with this paint. The coverage of this Rust-Oleum Aerosol Spray is 8-10 square feet. It features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Spray Paint for Plastic
- Suitable for interior and exterior conditions.
- Best for polypropylene, polystyrene resin, PVC, automotive and more.
- Fast drying and excellent coverage.
- Any-angle spray with comfort tip.
- Available in black, white, silver, clear and more.
NOTE: It is suggested to apply two light coats with the gap of few minutes to get best result.
How to apply Automotive Spray paint For Plastic?
Suitable Environmental Conditions
It is suggested to use it in the area of proper ventilation. Use in well-ventilated area like outdoors, garage. Use when temperature is between 50-90°F (10- 32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C). Avoid spraying in very windy and dusty conditions.
Make the surface ideal
For new plastic surfaces, thoroughly wipe down surface with paint thinner to promote adhesion. For aged or weathered surfaces, remove loose material with a brush or scraper, clean with soap and water, rinse and let dry. Sanding may be required for glossy or smooth surfaces. If mildew is present, wash with a bleach solution, rinse and let dry.
Application
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-12" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart. Maximum adhesion is achieved in 5-7 days. Do not use near open flame
Properties of Automotive Rust-Oleum Spray Paint for Plastic
Brand | Rust-Oleum |
---|---|
Resin Type | Modified Alkyd |
Pigment Type | Proprietary |
Solvents | Acetone and Aromatic Hydrocarbons |
MIR | 1.40 Max |
Practical Coverage at Recommended DFT |
8-10 sq.ft./can |
Fill Weight | 312 Grams |
Recommended Dry Film Thickness (DFT) Per Coat |
1.0-2.0 mil (25-50µ) |
Dry Times at 70-80°F (21-27°C) and 50% Relative Humidity |
20 minutes to touch and 1 hour to re-coat |
Shelf Life | 5 years |
Flash Point | -156°F (-104°C) |
Safety Information | For additional information, see MSDS |
Technical Data Sheet | Click here |