3541 3541 Zinsser

Rust-Oleum Zinsser Bulls Eye Oil-Base Primer

Product Code: 3541

Availability:In stock

Rs. 2,400.00 2,400.00

Zinsser Bulls-Eye Oil-Base Interior Primer-Sealer & Stain Killer is designed for interior applications where a heavybodied, fast-drying oil-based primer-sealer is needed. BullsEye dries in 2 hours to a flat finish that sands easily and accepts any latex or oil-based topcoat. Bulls-Eye effectively blocks stains, bright colors and graffiti on walls, ceilings, doors, trim, windows and cabinetry.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of Zinsser Bulls Eye Oil-Base Primer

  • High hiding
  • Blocks water stains, nicotine & graffiti
  • Sands easily
  • Dries fast and flat
  • Sticks to all surfaces without sanding
  • Works with all topcoats

How to Apply Zinsser Bulls Eye Oil Base Primer

Surface Preparation

Surfaces should be clean, dry, sound and free of any contamination, mildew, rust or unsound coatings that may interfere with adhesion. Remove loosely adhered or unsound coatings. Sand any remaining paint film edges smooth. If unsure of cleanliness, always wash surface with household ammonia and water solution, appropriate cleaning solution or solvent (do not use TSP as a cleaner). Rinse the surface thoroughly and allow to dry before application of Bulls-Eye Oil-Base.

Application

Apply only when air, material, and surface temperatures are between 40-90ºF (5-32ºC) and the relative humidity is below 85%. Thoroughly mix to ensure any settled pigment is redispersed before using. In most cases only one coat is necessary to prime most surfaces. If excessive absorption occurs over very porous substrates a second coat may be necessary. Spot priming is recommended only under highhiding topcoat finishes. For best results, prime entire surface before painting. Apply with a synthetic (nylon, polyester or blend) bristle brush, roller, or airless sprayer. Follow manufacturer's instructions when using spray equipment. For airless spraying use a 0.015" to 0.017" tip at 1500 to 2000 psi. Wear NIOSH approved respirator and provide adequate ventilation.

Properties of Rust-Oleum Zinsser Bulls Eye Oil-Base Primer

Brand Rust-Oleum Zinsser
Manufacturer Rust-Oleum
Resin Type Modified Alkyd
Pigment Type Titanium Dioxide
Solvents Aromatic Hydrocarbons
Weight 3.78 Ltr.
Volatile Organic Compounds <350 g="" l="" 2="" 91="" lbs="" gal="" td="">
Recommended Dry Film
Thickness (DFT) per Coat
1.5-2.5 mils
(37.5-62.5µ)
Wet Film to Achieve DFT
(Unthinned material)
2.5-4.5 mils
(62.5-112.5µ)
Practical Coverage at Recommended
DFT (assume 15% material loss)
Approximately 400 sq.ft./gal. (9.8 m2/l)
depending on application method and surface porosity
Dry Times at 70-80°
(21-27°C) and 50% RH
40 minutes to Touch
2 hours to Sand or Re-Coat
Shelf Life 5 years
Flash Point >200ºF (93ºC)
Storage Store indoors at 40-90°F (4-32°C)
Safety Information For additional information, see MSDS
Technical Data Sheet Click here