Wolman DeckStrip ASR Acrylic Stain Remover is a ready-touse, premium quality, exterior wood stripper for all types of acrylic deck and siding stains. In just 15 minutes, DeckStrip ASR will cut through and remove relatively new or weathered acrylic/latex solid and semi-solid stains, including those labeled 100% acrylic. With the aid of a highly concentrated formula, special wetting agents and a thickener for vertical surfaces, tough-to-remove acrylics are quickly dissolved and easily rinsed away with a pressure-washer – no scraping or sanding required. Once stripped, wood is restored to its bright, clean, natural look. Using DeckStrip ASR before re-application of a protective finish or stain ensures its proper adhesion, penetration and optimum performance.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Wolman DeckStrip-ASR Acrylic Satin Remover
- Safe to use - no methylene chloride or caustics.
- Spray on, pressure wash away.
- No scraping or sanding
- Clings to vertical surfaces for one application stripping.
- 100% Biodegradable – safe for grass, plants and shrubs.
How to Apply Wolman Deckstrip-ASR Acrylic Stain Remover
Use DeckStrip ASR to strip and restore outdoor wood decks, fences, siding, shakes and shingles, boat docks & boardwalks, outdoor furniture & décor, gazebos & arbors, play sets and more.
Before You Start :Make sure entire wood surface is dry and free of dust, dirt and debris. If the surface is hot to the touch or in direct sunlight, dampen with fresh water to cool. Apply when outside temperatures are above 40°F. Pre-rinse grass, plants and shrubs surrounding the wood structure to be stripped, then cover foliage to protect it from exposure to the product. Mask off siding and cover all wood surfaces not intended to be stripped. Cover any exposed aluminum surfaces (siding and flashing) to prevent corrosion. Protect adjacent concrete surfaces from rinse water. Sweep away surface dirt and debris. Remove any standing water before beginning application.
Properties of Wolman Deckstrip-ASR Acrylic Stain Remover
|Active Ingredient||Sodium Hydroxide|
|Solvent||Ethylene Glycol Monobutyl Ether,
Propylene Glycol, Water
|Dry Times @ 70-80ºF
(21-27°C) and 50% RH
|Allow wood to dry thoroughly before
applying a water-based stain or finish.
Allow a minimum of 24 hours before
applying an oil-based stain or finish.
|Shelf Life||2 years|
|Flash Point||>200°F (93°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|