Wolman DeckBrite Wood Cleaner & Coating Prep is an oxygen-activated powder concentrate cleaner for weathered wood and a coating preparation for new wood. When mixed with water, DeckBrite quickly and safely restores dirty, weatheredgray, mildew and algae-stained wood to its bright, natural, like new look. In just 10 minutes, the oxygen-powered foaming action deep cleans and removes stains without damaging the wood’s cell structure or leaving a bleached out appearance. DeckBrite also clears away traces of old water sealers from weathered wood and invisible coating barriers (such as “mill glaze” or excess surface wax) from new wood, enabling proper adhesion and penetration of protective sealers or stains. Also, the 100% biodegradable, acid and chlorine-free solution is harmless to surrounding plant life.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Wolman DeckBrite
- Oxygen activated, deep cleaning foam
- Environmentally safe, acid-free, chlorine-free
- Restores wood to its natural look
- Prepares surface for sealing and staining
How to Apply Wolman DeckBrite
Use DeckBrite to prepare or restore outdoor wood decks, fences, siding, shakes & shingles, boat docks & boardwalks, outdoor furniture and décor, gazebos & arbors, play sets and more. Removes from weathered wood, ground-in dirt, mildew, mold & algae stains, weathered gray surface, old sealers & clear finishes.
Make sure entire wood surface is dry and free of dust, dirt and debris. If the surface is hot to the touch or in direct sunlight, dampen with fresh water to cool. Apply when outside temperature is above 40°F (4°C). Working on 5-10 boards (20 square foot areas) at a time, pre-wet the surface with fresh water, then apply the solution with a pump sprayer, brush, mop or roller. Let sit and foam for 10 minutes. If solution dries prematurely, keep it wet with additional solution as needed.
Properties of Wolman DeckBrite
|Physical Properties||Oxygenated Powder Concentrate|
|Active Ingredient||Sodium Percarbonate|
|Ph in solution||10.5|
|Dry Time||Allow wood to dry thoroughly before applying a wate
based finish. Allow a minimum of 24 hours
before applying oil based stain or finish.
|Biodegradable||Biodegrades to oxygen, water and soda ash|
|Toxicity||Classified by FDA as Generally Recognized As Safe (GRAS)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|