Rust-Oleum Wipe New Wheels and Rim Restoration

Product Code: WWRTLKIT

Availability:Out of stock

Rust-Oleum Wipe New Wheels Restores the shining of your wheels and trim. One application is sufficient to renew and protect the surface from brake dust, road salt, grim, and corrosion etc. This is an innovative which allows you to complete the task in one step. Just wipe and you are done! For best result, don't apply on hot surface or direct sunlight as it may cause appearance of streaked. Before you apply, make sure that rims are clean and dry.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of Wipe New Wheel Restoration

  • One step application.
  • Long lasting protection.
  • Economical to use.
  • Renew wheels and trim.

NOTE: NOTE: Read and follow the instructions carefully before application.

How to Restore Wheel and Rim with Wipe New Wheels?

Surface Preparation

Before opening the Wipe-It packet, prep all wheels intended for coating so that you can complete your Wipe New application within a few minutes after opening the packet. Once the packet is opened, the Wipe-It begins to dry. Do NOT open the Wipe-It until you are ready to use it.

Wash your wheels thoroughly with a cleansing agent and scrub brush to remove all brake dust, oils, and dirt. Rinse and inspect to ensure all dirt and stains are completely removed. Repeat as necessary until the surface is completely clean. Ensure all wheels are clean, dry, and cool to the touch before applying Wipe New


Use when temperatures are between 40°F and 90°F (4°C and 32°C). Use in well ventilated and covered areas away from the sun. Do not apply Wipe New to hot surfaces or in direct sunlight. Ensure surface is clean, dry and cool to ambient temperature before applying Wipe New.

Put on the chemical resistant gloves and ensure that you are in a well ventilated area and that the wheels are completely dry. Tear open the Wipe-It packet, pull out the applicator cloth and carefully wipe the lens ONE TIME in a single wipe, from one row to the next, with a slight overlap (like mowing a lawn) until the surface is completely coated. Dab the included detail swab brush into the applicator cloth and use it to apply Wipe New into lug nut holes and other tight areas. Tip: Start from the tire valve stem to mark your position and work your way around the wheel until you come back to the tire valve stem. Coat the wheels on one side of the car at the same time, then open the second Wipe-It and repeat the process on the other side of the car. If Wipe New begins to dry on the applicator cloth, streaking may occur. Once the applicator cloth dries out completely, it cannot be reused and must be discarded.

Properties of Wipe New Wheels

Brand Wipe New
Manufacturer Rust-Oleum
Resin Type Siloxane Polymer
Pigment Type NA
Solvents Parachlorobenzotrifluoride
California - N-Butyl Acetate,Parachlorobenzotrifluoride G
Volatile Organic Compounds None
Practical Coverage One Wipe-It contains enough Wipe New to treat two wheels.
Dry Times at 70-80°
(21-27°C) and 50% RH
1 hour to Touch
NA to Re-Coat
24 hours to Full Care
Shelf Life 5 years
Flash Point 54°F (12°C)
California: 97°F (36°C)
Safety Information For additional information, see MSDS
Technical Data Sheet Click here