Varathane Premium Fast Dry Wood Stains are high performance stains enhanced with nano pigments and soy oil for exceptional color clarity. This innovative formula creates rich, one coat coverage with a one hour dry time. Fast dry wood stains seals pores and dries just in an hour. This nano pigment innovative formula is made for interior projects. It can be used for furniture, cabinets, doors and trims.
Features of Fast Dry Wood Stain
- Get the desire color in single coat.
- Wood Conditioner is not necessary.
- Economical to use as serve 225-275 square feet of coverage in a liter only.
- Available in unique colors for wood beautification.
NOTE: This product is not recommended to use for exterior surface.
Properties of Varathane Premium Fast Dry Wood Stains
|Resin Type||Urethane Modified Alkyd|
|Weight||236 ml and 946 ml|
|Volatile Organic Compounds||
Recommended Dry Film
Thickness (DFT) Per Coat
Wet Film to Achieve DFT
Dry Times at 70-80°F
(21-27°C) and 50% RH
1 hour to Touch
1 hour to Re-coat
24 hours to Full Care
3 days to Normal Use
|Shelf Life||3 years|
|Flash Point||>100°F (38°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|
How to Apply Rust-Oleum Varathane Premium Fast Dry Wood Stains?
Remove any existing finishes with sandpaper or paint stripper. Prepare bare wood for staining by sanding in the direction of the grain. Begin with 120 grit sandpaper and progress though 150, 180 and 220 grits. Before staining, remove all sanding dust and dirt with a vacuum and grease or glue with a clean rag dampened with mineral spirits.
Apply when temperatures are between 60-90°F (16-38°C) and the relative humidity is below 85%. Allow longer dry times for damp, humid days. Use adequate ventilation at all times. Use full strength. Do not dilute. Stir or shake the container thoroughly before and occasionally during use.
Apply a test sample on a small inconspicuous area before proceeding with the entire job. Apply one coat of stain liberally with a good quality brush or clean lint free rag. Allow to penetrate for 5-10 minutes then remove excess by wiping with a rag in the direction of the grain. Removal of all excess material is essential to ensure proper dry time and proper adhesion of topcoat.