Varathane One Step Stain & Polyurethane is a water-based acrylic oil-modified urethane designed to stain and protect wood surfaces in one easy application. By combining a stain with polyurethane, the need for multiple product application is eliminated. Varathane One Step Stain & Polyurethane adds rich color and a smooth protective finish. It has fast dry, low odor, and the convenience of soap and water clean-up. It is suitable for use on interior wood furniture, trim, cabinets, and doors. It is not recommended for use on exterior surfaces.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of Water-Based One Step Stain & PU

Indoor use only.
Fast Drying
Deep, rich color.
Stain and Polyurethane combined into one step.

NOTE: Prepare bare wood for staining by sanding in the direction of the grain.

How to Apply Water Based Varathane One Step Stain and Polyurethane

Surface Preparation

Wood Surfaces - Remove any existing coatings using sandpaper or stripper. Prepare bare wood for staining by sanding in the direction of the grain. Begin with #120 grit sandpaper and progress through #150, #180 and #220 grits. Remove all sanding dust with a vacuum or clean rag dampened with mineral spirits.

CONDITIONING - Soft woods such as pine, fir and maple require a wood conditioner. Use Varathane Premium Wood Conditioner before staining.

Application

Use adequate ventilation at all times. Stir thoroughly before use. Do not shake. Apply when temperatures are between 50-90°F (10-38°C) and the relative humidity less than 85%. Apply One Step Stain & Polyurethane using a high quality synthetic bristle brush in the direction of the grain until a uniform film has been achieved. To prevent brush marks, avoid excessive brushing. Additional coats can be applied allowing one hour dry time between coats. Lightly sand between coats with #320 grit sandpaper. Remove all sanding dust before applying additional coats.

Properties of Varathane Water Based One Step Stain and Polyurethane

Brand	Varathane
Manufacturer	Rust-Oleum
Resin Type	Water-based Acrylic Oil-modified Urethane
Pigment Type	Micro particle Organic Pigments
Solvents	Glycol ethers, n-Methyl Pyrrolidone, Water
Weight	946 ml
Recommended Dry Film Thickness (DFT) Per Coat	1.0-1.5 mils (25-37.5µ)
Practical Coverage at Recommended DFT	70-110 sq.ft./quart (assumes 15% material loss)
Dry Times at 77°F (25°C) and 50% RH	1 hour to touch and re-coat and fully dry into 24 hours
Shelf Life	3 years
Flash Point	200°F (93°C)
Safety Information	For additional information, see MSDS
Technical Data Sheet	Click here

Varathane One Step Stain and Polyurethane - Water-Based

Have a question?