Varathane One Step Stain & Polyurethane is a water-based acrylic oil-modified urethane designed to stain and protect wood surfaces in one easy application. By combining a stain with polyurethane, the need for multiple product application is eliminated. Varathane One Step Stain & Polyurethane adds rich color and a smooth protective finish. It has fast dry, low odor, and the convenience of soap and water clean-up. It is suitable for use on interior wood furniture, trim, cabinets, and doors. It is not recommended for use on exterior surfaces.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Water-Based One Step Stain & PU
- Indoor use only.
- Fast Drying
- Deep, rich color.
- Stain and Polyurethane combined into one step.
NOTE: Prepare bare wood for staining by sanding in the direction of the grain.
How to Apply Water Based Varathane One Step Stain and Polyurethane
Wood Surfaces - Remove any existing coatings using sandpaper or stripper. Prepare bare wood for staining by sanding in the direction of the grain. Begin with #120 grit sandpaper and progress through #150, #180 and #220 grits. Remove all sanding dust with a vacuum or clean rag dampened with mineral spirits.
CONDITIONING - Soft woods such as pine, fir and maple require a wood conditioner. Use Varathane Premium Wood Conditioner before staining.
Use adequate ventilation at all times. Stir thoroughly before use. Do not shake. Apply when temperatures are between 50-90°F (10-38°C) and the relative humidity less than 85%. Apply One Step Stain & Polyurethane using a high quality synthetic bristle brush in the direction of the grain until a uniform film has been achieved. To prevent brush marks, avoid excessive brushing. Additional coats can be applied allowing one hour dry time between coats. Lightly sand between coats with #320 grit sandpaper. Remove all sanding dust before applying additional coats.
Properties of Varathane Water Based One Step Stain and Polyurethane
|Resin Type||Water-based Acrylic Oil-modified Urethane|
|Pigment Type||Micro particle Organic Pigments|
|Solvents||Glycol ethers, n-Methyl Pyrrolidone, Water|
|Recommended Dry Film
Thickness (DFT) Per Coat
|1.0-1.5 mils (25-37.5µ)|
at Recommended DFT
(assumes 15% material loss)
|Dry Times at 77°F (25°C)
and 50% RH
|1 hour to touch and re-coat and
fully dry into 24 hours
|Shelf Life||3 years|
|Flash Point||200°F (93°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|