5494323 5494323 TurboKrete

Rust-Oleum TurboKrete Concrete Patching Compound - 3.5 Gallon Kit

Product Code: 5494323

Availability:Out of stock

TurboKrete Concrete Patching Compound is a resin rich epoxy/aggregate patching compound designed for quick patch repair of concrete floors in areas exposed to intermittent chemical exposure and physical abuse.

TurboKrete Concrete Patching Compound is designed for patching repairs to concrete floors when down time is critical. It is a stand-alone material which does not require a sealer for exposure to moderate chemical spills. It can be applied in a single step application with hand trowel finishing. The 100% solids epoxy is odorless making it ideal for food and beverage plants or other facilities where solvent odors cannot be tolerated.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of TurboKrete Concrete Patching Compound

  • Protects against abrasion, impact and most chemicals—no sealer required
  • Creates an extremely hard surface—3–4 times stronger than concrete
  • Dries quickly—can accept light traffic in 1.5–4 hours; heavy traffic in 6–8 hours
  • For interior/exterior use on damaged or severely spalled floors, curbs, ramps, etc.; odorless
  • Easy-mix kit includes base, activator and aggregate

Featured Video of TurboKrete Patching Compound

How to Apply TurboKrete Concrete Patching Compound

Surface Preparation

New concrete must cure 28 days at 70°F (21°C) before repairs are made. Remove all dirt, grease, oil, salt or other contaminants by washing surface with 3500 System Pure Strength, Cleaner/Degreaser, commercial detergent or other suitable cleaner. Rinse thoroughly with fresh, clean water and allow to dry. Remove all loose, unsound, or deteriorated concrete. Abrasive blast or acid etch new or smooth concrete to create a uniform surface profile.

Note : The material, surface, and air temperatures should all be between 45-90°F (7-32°C) before mixing or installing TurboKrete Concrete Patching Compound.


Immediately after mixing apply the TurboKrete Concrete Patching Compound in the area to be repaired, then work the material smooth using a hand held steel trowel. Wet the blade of the trowel with 160 Thinner to help ease the final finishing of the material.

TurboKrete Concrete Patching Compound can be applied up to a maximum thickness 8 inches in a single horizontal application.

Properties of TurboKrete Concrete Patching Compound

Manufacturer Rust-Oleum
Resin Type Polyamine epoxy
Pigment Type Mineral aggregate
Coverage Per Kit Large Kit: 0.30 cu ft; Small Kit: 0.15 cu ft
Pot Life @ 70-80°F (21-27°C)
& 50% RH
30 minutes
Dry Times at 70-80°
(21-27°C) and 50% RH
(2½ - 4 hours with patch thickness less than 1 inch,
1½ - 4 hours with patch thickness greater than 1 inch) to Foot Traffic
2-4 hour to Topcoat
6-8 hours to Vehile Traffic
3 days to Full Chemical Exposure
Shelf Life 2 years
Safety Information For additional information, see MSDS
Technical Data Sheet Click here