Rust-Oleum Automotive Trim and Bumper Spray Paint is prepared to renew and restore the original equipment manufacturer (OEM) finishes found on vehicles. Trim and Bumper Paint is ideal for metal trim, moldings, plastic mirror covers, and rub strips. Rust-Oleum Trim & Bumper Paint features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying. This rust preventive formula is available in black and charcoal gray.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Rust-Oleum Trim & Bumper Spray Paint
- Delivers excellent coverage up to 10-15 square feet.
- Restore and renew the faded color.
- Fast drying.
- Fast drying.
- Exact color match that is found on most of the car.
NOTE: Apply 2 or 3 light coats few minutes apart to achieve the best appearance.
Featured Video of Rust-Oleum Trim And Bumper Scratch Paint Application
How to Trim And Bumper Scratch Repair Spray Paint?
Appropriate Conditions to Use
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50°F (10°C) and 90°F (32°C) and humidity is below 85% to ensure proper drying. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Remove all dirt, wax, and grease from the surface with Wax And Tar Remover. Wash the area with a mild soap and water solution, fresh with fresh water, and dry with a clean cloth.
Use Primer For Best Reults
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 12-16" from the surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. For best results, apply 2-3 light coats a few minutes apart. Do not use near open flame.
Properties of Rust-Oleum Trim And Bumper Spray Paint
|Resin Type||Modified Alkyd|
|Pigment Type||Carbon Black|
|Solvents||Acetone, Aliphatic and Aromatic Hydrocarbons|
Recommended Dry Film
Thickness (DFT) Per Coat
|1.0-2.0 mils (25-50µ)|
at Recommended DFT
|10-15 sq. ft./can|
Dry Times at 70-80°F
(21-27°C) and 50% Relative Humidity
|20 minutes to touch and re-coat within 1 or after 24 hours|
|Shelf Life||5 years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|