Rust-Oleum Stops Rust Protective Enamel Spray Paint is best choice if you are searching for rust preventive paint for general purposes. This is available in several good looking colors with gloss, semi-gloss, and satin finishes. This aerosol coating offers excellent resistance to fading, chipping and dulling. This is ideal to be used for metallic and non-metallic surfaces but not suggested for galvanized metals.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Enamel Touch Up Spray Paint
- Makes the surface new.
- Best rust preventive paint for general purposes.
- Available in more than 50 colors.
- Serve long lasting durability to both interior and exterior surface.
NOTE: Use Rust-Oleum Stops Rust Rusty Metal Primer Spray for heavily rusted surface.
Featured Video of Rust-Oleum Stops Rust Enamel Touch Up Spray Paint
How to Use Stops Rust Protective Enamel Spray Paint?
Appropriate Environmental Conditions to Use
Use outdoors or in a well ventilated area such as an open garage. Apply when temperature is between 50-90°F (10-32°C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C). Do not apply to galvanized steel. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Prepare Surface For Best Result
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 10-16" from the surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart to avoid runs and sags. Metallic Sprays are not recommended for outdoor use. Do not use near open flame.
Properties of Rust-Oleum Stops Rust Enamel Touch Up Spray Paint
|Resin Type||Oil modified Alkyd|
|Pigment Type||Varies with color|
|Solvents||Acetone, N-Butyl Acetate, Aromatic Hydrocarbons|
Recommended Dry Film
Thickness (DFT) Per Coat
|1.0-2.0 mils (25-50µ)|
at Recommended DFT
|10-12 sq. ft./can|
|Dry Times at 70-80°F (21-27°C)
and 50% Relative Humidity
|2-4 hours to touch and re-coat before 1 hour or after 24 hours|
|Dry Heat Resistance||200°F (93°C)|
|Shelf Life||5 years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|