Stops Rust Cold Galvanizing Compound Spray
Product Code: 7785830
Availability:Out of stock
Have a question?
Stops Rust Cold Galvanizing Compound Spray contains 93 percent of zinc, hence it provide utmost protection to galvanized steel, galvanized ducts, fences, gutters, trucks, trailers etc. from rust/corrosion. This spray is perfect to use for DIY jobs such as touch-ups and repair. The coverage of single aerosol cane is 8-12 sq.ft. It get dries within 15 minutes to touch.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Cold Galvanizing Spray
- Excellent coverage.
- Suitable to use for interior and exterior surfaces.
- Easy to use as available in aerosol spray cane.
- Fast drying spray.
NOTE: It not recommended to top coat it with alkyd coating.
How to Apply Stops Rust Cold Galvanizing Compound Spray Paint
Surface Preparation
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper.
Application
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply two or more light coats a few minutes apart to avoid drips and runs. Do not use near open flame.
Properties of Stops Rust Cold Galvanizing Spray Paint
Brand | Stops Rust |
---|---|
Manufacturer | Rust-Oleum |
Resin Type | Epoxy Easter |
Pigment Type | Metallic Zinc |
Weight | 454 gr |
MIR | 1.2 Max |
Fill Weight | 16 ounces |
Solvents | Acetone, Toluene, Xylene |
Recommended Dry Film Thickness (DFT) Per Coat |
1.0-2.0 mils (25-50µ) |
Dry Times at 70-80°F (21-27°C) and 50% RH |
15 minutes to Touch 1-2 hours to Handle Within 1 hour or after 24 hours to Re-Coat 24 hours to Fully Dry |
Dry Heat Resistance | 200°F (93°C) |
Shelf Life | 5 years |
Flash Point | -156°F (-104°C) |
Safety Information | For additional information, see MSDS |
Technical Data Sheet | Click here |