Rust-Oleum Specialty Tub and Tile Aerosol Spray Paint is a one-step solution to renew sinks, tub, shower and more. This spray is particularly manufactured to for high moisture areas to provide adhesion, durability and color retention. The coverage of this waterproof paint is 10-15 square feet per cane which makes it very economical.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Tub and Tile Spray Paint
- One step solution to renew high moisture areas.
- Long lasting.
- Excellent coverage.
- Tough and hard protective coating acts like porcelain or ceramic.
NOTE: Tub and tile paint in brush on is also available.
How to Use Specialty Tub and Tile Aerosol Spray Paint?
Appropriate Conditions to Use
Use in a well ventilatedarea when air and surface temperatures are between 50-90°F and the relative humidity is below 80% to ensure proper drying. This product is not for use on galvanized metal or other metal surfaces.
Surface Preparation for Best Result
Remove metal drains and hardware. Remove loose paint and rust with a wire brush or sandpaper. Repair chips and cracks with a patching compound similar to Liquid Steel.
Remove any mildew with a solution of bleach and water and rinse thoroughly. Repeat if necessary. Scrub surface with and abrasive pad and abrasive cleaner like Comet to remove all dirt, grease, mold, oil, soap film and hard water deposits. Remove all caulk and wipe those areas with a non-oily solvent such as isopropyl alcohol.
Prepare surface with an abrasive pad and Lime-A-Way cleaner to create a slightly porous surface for strong adhesion. Allow to stand for 5 minutes. Scrub the entire surface again and rinse with fresh water. Sand entire surface with #400/#600 grit wet/dry sandpaper. Rinse the surface thoroughly with fresh water to remove all residue.
Allow the surface to dry for at least 90 minutes before applying paint. Wipe the surface with a tack cloth immediately before painting to remove any remaining dust and lint. Always test product in a small, hidden area before painting.
Application / Spraying
Open any windows and/or use fans to properly ventilate the area. Shake can vigorously for one minute after the mixing ball begins to rattle. Shake often during use. Hold can 10-16" from surface and spray in a steady back-andforth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply 2-3 light coats, spraying horizontally and vertically. Do not use near open flame.
Properties of Rust-Oleum Tub and Tile Spray Paint
|Resin Type||Acrylic Epoxy|
|Pigment Type||Titanium Dioxide, Calcium Carbonate|
|Solvents||Acetone, Toluene, Xylene, PM Acetate|
|Practical Coverage at Recommended
DFT (assumes 15% material loss)
|Approximately 10-15 sq. ft./can|
|Dry Times at 70-80°F (21-27°C)
and 50% Relative Humidity
|15 minutes to touch and re-coat any-time|
|Dry Heat Resistance||200°F (93°C)|
|Shelf Life||2 years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|