Rust-Oleum Rippled Effect Spray is manufactured for the decoration of glass. This spray delivers a semi-transparent coating which gives wet look to the surface (glass). This is great for decorating window panes, glass vases, lamps, candle holders and more.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Rippled Effect Spray
- Add texture to create a luxurious finish on ordinary glass or plexi-glass is one easy step.
- Rippled, wet glass texture semi-transparent clear coating.
- Transforms texture while still allowing light to come through.
- Fast drying.
- Coverage up to 9-11 square feet.
NOTE: Don’t use for exteriors.
Featured Video of Specialty Rippled Effect Spray
How to Use Rust-Oleum Rippled Effect Spray?
Suitable Conditions to Spray
Use with adequate ventilation. Use when the temperature is between 50-90°F (10-32°C) and humidity is below 85% to ensure proper drying. Cover surrounding area to protect from spray mist.
Clean surface thoroughly with glass cleaner or soap and water using a lint-free cloth. Allow glass to dry completely before painting
Application / Spraying
Shake can vigorously for one minute after mixing ball begins to rattle. If mixing ball fails to rattle, DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. For a finer texture, hold the can upright 12-14 inches from the surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Apply using very thin coats. Keep the can the same distance from the surface and keep the can in motion while spraying. For a larger texture, hold the can upright 10-12 inches from the surface and spray in a slow but steady back and forth motion keeping the can the same distance from the surface and in motion while spraying. The wet look will appear shiny once applied to the surface. Apply 3-5 coats. The effect will be enhanced by more applied coats.
Properties of Rust-Oleum Rippled Effect Spray
|Resin Type||Acrylic Lacquer|
|Solvents||Acetone, Methyl Ethyl Ketone, N-Butyl Acetate, Xylene|
|Recommended Dry Film Thickness
(DFT) Per Coat
|1.0-2.5 mils (25-62.5µ)|
|Practical Coverage at Recommended
DFT (assumes 15% material loss)
|Dry Times at 70-80°F (21-27°C)
and 50% Relative Humidity
|5 minutes to touch and re-coat any-time|
|Shelf Life||5 years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|