Rust-Oleum Specialty High Heat Protective Enamel Brush On Paint - Satin Black
Product Code: 7778502
Availability:Out of stock
Have a question?
Rust-Oleum® Specialty High Heat retains color and finish up to 1200º F. It is suitable for grills, wood-burning stoves, radiators, engines and other metal items. Provides excellent rust protection and create a rich, satin finish look.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Specialty High Heat Protective Enamel Paint
- Indoor/outdoor.
- Durable, corrosion-resistant.
How to Apply Specialty High Heat Protective Paint
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90ºF (10- 32ºC) and humidity is below 85% to ensure proper drying. Priming is not recommended. Do not use on metal directly exposed to open flame or in direct contact with food, such as a grill grate. If using sprays, avoid application in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.
APPLICATION
Sprays: Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16” from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply two or more light coats a few minutes apart to avoid drips and runs. Do not use near open flame.
Brush Goods: Mix thoroughly to ensure any settled pigment is re-dispersed. Thin material only if necessary with mineral spirits. For brush or roller application, thin no more than 5%. Do not thin with gasoline, lacquer thinner, turpentine, etc. Apply with a good quality brush, nap roller, or conventional spray gun. A second coat is not recommended.
Properties of Specialty High Heat Protective Enamel Brush On Paint
Brand | Rust-Oleum |
---|---|
Weight | 946 ml |
Recommended Dry Film Thickness (DFT) per Coat |
1.0-2.0 mils (25-50µ) |
Practical Coverage at Recommended DFT (assumes 15% material loss) |
260-520 sq.ft./gal. (6.4-12.8 m2 /l) |
Dry Times at 70-80F (21-27°C) and 50% Relative Humidity |
2-4 hours to touch, 5-9 hours to handle 24 hours to fully cure |
Resin Type | Silicone Modified Alkyd |
Pigment Type | Black Manganese Ferrite, Chromite Black |
Solvents | Aromatic Mineral Spirits |
Dry Heat Resistance | 1200°F (648°C) |
Flash Point | 104°F (40°C) |
Shelf Life | 5 Years |
Safety Information | For additional information, see MSDS |
Technical Data Sheet | Click here |