Rust-Oleum Frosted Glass Spray is an innovative semi-transparent coating which creates etching like effect. This spray is amazing for interior decoration. You can use it with stencil to make custom designs over glass, mirrors and more. The coverage of this spray is 7 square feet (assuming 15% of material loss). This spray paint takes 5-10 minutes to dry so that you can complete your job in a short period of time.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of Frosted Glass Spray

Delivers etched glass look to shower doors, windows, mirrors etc.
Tough acrylic resin.
Fast drying.
Ideal for decoration.

NOTE: This is not recommended to exteriors.

How to Use Rust-Oleum Frosted Glass Spray?

Ideal Conditions to Spray

Use outdoors or in a well ventilated area. Use when temperature is between 50-90°F (10-32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C) or surfaces that are exposed to repeated or continuous water contact, such as the inside of shower doors. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.

Surface Preparation

Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry.

Application / Spraying

Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Hold can upright 10-16" from surface and spray in a steady back and forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply two or more wet coats a few minutes apart for best appearance. A wet coat should appear shiny as it is applied to the surfaces. WAIT 10 MINUTES FOR FROST EFFECT. Not for outdoor use. Do not use nearopen flame

Properties of Rust-Oleum Specialty Frosted Glass Spray

Brand	SPECIALTY
Manufacturer	Rust-Oleum
Resin Type	Acrylic Lacquer
Pigment Type	Proprietary
Solvents	Acetone, N-Butyl Acetate, Xylene
Weight	312 Grams
Practical Coverage at Recommended DFT (assumes 15% material loss)	Approximately 7 sq.ft./can
Dry Times at 70-80°F (21-27°C) and 50% Relative Humidity	5 minutes to touch, fully dry in 10 minuets, and re-coat any-time
Dry Heat Resistance	200°F (93°C)
Shelf Life	5 years
Flash Point	-156°F (-104°C)
Safety Information	For additional information, see MSDS
Technical Data Sheet	Click here

Rust-Oleum Specialty Frosted Glass Spray Paint

Have a question?