Rust-Oleum Specialty Triple Thick Glaze Spray
Rust-Oleum Triple Thick Glaze Spray is manufactured for the protection of wood, paper, plaster, metal, wicker, glass, plastic, and ceramic. This forms a clear thick glass-like coating over the surface to protect from scratches and stains. This is compatible for using interiors and exteriors. This acrylic based formula takes 5 minutes to dry (to touch). The coverage of one triple thick glaze spray is 10-12 square feet.
Features of Triple Thick Glaze Spray
- Creates a fire-glazed high-gloss look without the heat.
- Great for use on wood, metal, glass, plastic, ceramic and more.
- Ideal for indoor and outdoor.
NOTE: Use painters touch primer wood and metal. This will promote adhesion.
Featured Video of Clear Triple Thick Glaze Spray
How to Use Rust-Oleum Triple Thick Glaze Spray?
Suitable Conditions to Use
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90ºF (10-32ºC) and humidity is below 65% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C), or galvanized steel. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Surface Preparation for best result
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces to create a surface profile.
Application / Spraying
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 8-10” from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply two or more light coats a few minutes apart. Do not use near open flame.
Properties of Rust-Oleum Clear Triple Thick Glaze Spray
|Solvents||Acetone, Toluene, Ethyl 3-Ethoxypropionate|
|Recommended Dry Film Thickness
(DFT) per Coat
|4.0-5.0 mils (100-125µ)|
|Practical Coverage at Recommended
DFT (assumes 15% material loss)
|Dry Times at 70-80°F (21-27°C)
and 50% Relative Humidity
|5 minutes to touch and 24 hours to fully dry|
|Shelf Life||5 years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|