46504 46504 Truworth Homes

Rust-Oleum Restore 10X Deck & Concrete - Beach Color

Product Code: 46504

Availability:Out of stock

Restore Deck & Concrete 10X is a high build, water based acrylic coating designed to resurface aged wood and concrete decks, patios, and walkways. The high build textured finish provide slip resistance and can bridge over or fill small cracks, checks, nail holes, or other minor surface defects.

For Decks : For horizontal wood and most composite decks. New wood decks need to age at least six months before application. Follow specific manufacturer’s recommendation before applying to any composite decking.

For Concrete : For use on broom swept or porous concrete surfaces. Do not use on smooth or floated concrete. Not recommended for driveways, garages or other areas with vehicular traffic

Features of Resore 10X Deck & Concrete

  • Revives wood & broom swept concrete
  • Lasting moisture protection
  • Provides slip resistance
  • Fills cracks up to ¼”
  • One-part, ready-to-use after tinting
  • Locks down wood splinters

Featured Video of restore 10X Deck & Concrete

How to Apply Restore 10X Deck & Concrete

Surface Preparation

Long term adhesion and durability can be impaired by a poorly prepared surface.

Light Repaires : Secure raised nail heads, deck screws or loose deck boards. Prime nail heads with a water-based metal primer for rust. Remove loose splinters and replace severely damaged or rotting boards. Fill cracks of more than ¼” with Restore Crack Filler™ or similar acrylic, non-silicone filler. Allow to dry

Clean : The surface must be porous, clean and free of dirt, grease, mildew and organic growth. Clean the surface using a stiff bristle brush and Restore Deck & Concrete Cleaner™ . For tough stains, grease spots and embedded dirt, a pressure washer may provide the best results. Loose paint needs to be scraped and then sanded with 50 grit sandpaper.


Using either a 4” or 9” Restore Roller, saturate the roller cover and roll in one direction with a slight downward pressure to maintain texture and to push material into cracks and voids. Work to a wet edge at all times. Avoid rolling back into coated areas where drying has begun. Coat 1 to 2 boards at a time.

Use a putty knife or other straight edge to remove excess coating between boards. Difficult areas such as warped or cupped boards will require rolling across the narrow width of the board as well as the length to ensure complete coverage. Allow the first coat to dry 4-6 hours. Extend the dry time if the surface is tacky or soft. Drying times vary depending on temperature and humidity. Apply a second coat using the same method described above. Allow the second coat to dry for 24 hours before light foot traffic and 3-5 days before replacing furniture. If the surface is tacky or soft, extend the drying time before putting heavy objects back in place. Full cure to a hard finish will take approximately 3- 4 weeks.

Properties of Restore 10X Deck & Concrete

Brand Rust-Oleum Restore
Manufacturer Rust-Oleum
Resin Type Water-based Acrylic
Pigment Type A blend of inorganic and organic pigments
Solvents Glycol Ethers, Water
Weight 15.12 Ltr.
Volatile Organic Compounds <50 g/l (0.42 lbs./gal.)
Practical Coverage Approximately 25 sq.ft./3.78 Ltr. (volume after tinting) Two coats are required
Dry Times at 70-80°
(21-27°C) and 50% RH
2 hours to Touch
4-6 hours to Re-Coat
24 hours to Light Traffic
3-4 weeks to Full Care
Shelf Life 3-4 years
Flash Point >200ºF (93ºC)
Storage Protect from freezing
Safety Information For additional information, see MSDS
Technical Data Sheet Click here