For longer-lasting, better-looking paint on aluminum surfaces choose Rust-Oleum Professional Aluminum Primer Spray. This durable, spray-on base coat ensures a tight-binding top coat that eliminates the problems of blistering, flaking and peeling.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of the Product
- Durable, corrosion resistant.
- Adds twice the protection.
How to Apply Professional Aluminum Primer
STEEL: Scrape and wire brush or power tool clean to remove loose rust, scale and deteriorated coatings. Use 7569 Red Primer for sound rusted or clean metal before application of a finish coat. 7582 Gray Primer is best for clean metal but may be used on sound rusted metal as well.
PREVIOUSLY COATED: Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile. Removal of old paint by sanding, scraping or other means may generate dust or fumes that contain lead.
Apply only when air and surface temperatures are between 50-90°F (10-32°C) and relative humidity is below 85% to ensure proper drying. Protect surrounding area from overspray. Overspray can carry a significant distance. Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart to avoid drips and runs.
Properties of Rust-Oleum Professional Aluminum Primer
|Weight||425 Grams Spray|
|Resin Type||Modified Alkyd||Acrylic Polymer|
|MIR||Primers and Flats – 1.20 Max
Non-Flats – 1.40 Max
|Fill Weight||15 oz.||14 oz.|
|Practical Coverage at
Recommended DFT (assumes 15%
|Approximately 14 sq. ft./can
|Dry Times at 70°F
(21°C) and 50%
|15 minutes to Touch.
1-2 hours to Handle
Within 1 hour or after 48 hours to Re-Coat
|Dry Heat Resistance||200°F (93°C)|
|Shelf Life||5 years)|
|Flash Point||-156°F (-104°C)|
|Technical Data Sheet||Click here|