Rust-Oleum Okon Penetrating Acrylic Barriers Multi-Surface
Product Code: OK930
Availability:Out of stock
Have a question?
OKON Multi-Surface Water Repellent Sealer is an easyto-use multi-surface water repellent and sealer. It helps protect porous concrete or wood from the damaging effects of water absorption. Water is a major cause of premature deterioration of many building materials. In concrete water causes efflorescence, mold, freeze-thaw damage, dusting and staining. In wood, water absorption causes splitting, cracking, warping rotting and mold. Multi-Surface helps prevent these occurrences by significantly reducing water absorption.
Multi-Surface is an acrylic/siloxane blend that provides protection long after the initial water-beading action has ended. A single application can last one to three years and can be easily refreshed with another application.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Okon Penetrating Barriers Multi- Surface
- For use on porous surfaces including concrete, wood, stucco, brick, adobe, canvas, plywood and pottery.
- Protects many types of structures: walls, floors, fences, decks, siding, patios and sidewalks
- Combines proprietary water-repellent with 100%acrylic resin and siloxane.
- Very low odor, low VOC and cleans up with soap and water
- Long lasting protection – 1-3 years depending on substrate and exposure conditions.
How to Apply Okon Panetrating Acrylic Barriers Multi-Surface
Surface Praeparation
Multi-Surface requires minimal surface preparation. It can be applied to most porous surfaces that are clean, free of dirt, waxes and oils, non-glossy surfaces and free from sub-surface moisture.
Clean: Sweep and hose-off exterior surfaces; vacuum and damp-mop interior surfaces. Use a degreaser to remove oil or grease stains. Use Jomax to remove exterior mildew and a wood brightener to remove gray weathered wood fibers.
Application
Multi-Surface is ready-to-use, no thinning is required. It can be applied by brush, roller or garden-type sprayer. Do not pour product onto surface to spread. Apply a uniform wet coat at the estimated spread rate. It appears milky-white when applied but dries clear. Material that is not absorbed should be back rolled or brushed out to avoid build up. Do not allow puddles, drips or runs to dry on the surface. Multi-Surface may slightly darken the surface and add a slight sheen. Stop application at expansion joints, walls or breaks defined with masking tape. The surface temperature at time of application is very important.
Properties of Okon Penetrating Acrylic Barriers Multi-Surface
Manufacturer | Rust-Oleum |
---|---|
Resin Type | Acrylic / Siloxane |
Color | Milky White in Can / Clear when Dry |
Solvents | Water |
Volatile Organic Compounds | <75 g/l (0.62 lbs./gal.) |
Dry Times at 70-80° (21-27°C) and 50% RH |
3 hours to Re-Coat 8 hours to Foot Traffic |
Protect From Rain | 24 hours |
Protect From Dew | 12 hours |
Shelf Life | 3 Years |
Flash Point | N/A |
Safety Information | For additional information, see MSDS |
Technical Data Sheet | Click here |