Easily touch up rebar coatings on the job site with Rust-Oleum Industrial Choice RB1600 System Green Rebar Epoxy Spray Paint. This one-step, direct-to-metal coating provides long-lasting resistance to corrosion and chemicals.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of RB1600 System Rebar Epoxy Spray
- Fast and easy to apply; minimal surface prep required.
- Dries to the touch in 15 minutes.
- Prevents rust and metal stains in concrete.
How to Apply RB1600 System Rebar Epoxy Spray
ALL SURFACES: Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with Krud Kutter® Original Cleaner Degreaser, commercial detergent or other suitable cleaner. Rinse immediately and thoroughly and allow to fully dry. Thoroughly cured, hard or gloss previous coatings which are very smooth may require scuff sanding to maximize adhesion.
Use when temperature is above 50°F (10°C) and humidity is below 85% to ensure proper drying. Surface temperature must be between 50°F and 100°F (10-38°C). Protect surrounding surfaces from overspray. Overspray can carry a significant distance. Shake can for one minute after mixing ball is heard. Hold can 10-14" from surface. Apply several light coats a few minutes apart to avoid drips and runs.
Properties of RB1600 System Rebar Epoxy Spray
|Resin Type||Epoxy Ester|
|Pigment Type||Titanium Dioxide, Iron Oxides|
|Solvents||Acetone, Butyl Acetate, Xylene|
|MIR||Maximum value of 0.95|
at Recommended DFT
|Fill Weight||340 Grams|
Recommended Dry Film
Thickness (DFT) Per Coat
|1.0-2.0 mils (25-50µ)|
Dry Times at 70-80°F
(21-27°C) and 50% Relative Humidity
|15 minutes to Touch and Recoat anytime Within 1 hour or after 24 hours|
|Dry Heat Resistance||93°C|
|Shelf Life||5 years|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|