301293 301293 Seal Krete

Rust-Oleum Concrete & Masonry Lacquer

Product Code: 301293

Availability:Out of stock

Rs. 9,800.00 Rs. 8,820.00 8,820.00

Rust-Oleum Wet Look Concrete & Masonry Lacquer seals and protects concrete and masonry surfaces from the damaging effects of water, chemicals, and UV light. The solvent- base formula forms an ultra-durable, protective barrier to keep water out, protect against stains, and extend the life of your concrete. Its “wet look”, high gloss finish beautifies decorative concrete, stone, pavers, and masonry, and it suitable for use on driveways, patios, walkways, and more. Application is quick and easy using a solvent-resistant pump sprayer or paint roller.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of the Product

  • Seals and enhances masonry, decorative concrete, pavers, natural stone and more.
  • Superior water repellency/Never Wet properties.
  • High gloss finish.
  • Long-lasting solvent-based formula.
  • Excellent protection against stains, chemicals, abrasion and grease.
  • Interior/Exterior use.

How to Apply Concrete & Masonry Lacquer

Surface Preparation

Proper surface preparation is critical to achieve best results. Allow newly poured concrete to cure for a minimum of 28 days. Sweep away all loose dirt, debris and remove any vegetation that could interfere with application and performance. If necessary, use a wire brush or sander to remove any loose or unsound concrete or masonry. Remove any efflorescence with efflorescence remover (sold separately). Clean the entire surface, including any oil or grease spots with heavy duty cleaner (sold separately). Scrub with a stiff bristle brush or broom. Rinse thoroughly with fresh water. A power washer is preferred. Repeat as necessary to completely clean and rinse. Allow to dry completely before sealing. Hazing may occur if lacquer is applied to a damp surface.


Wet Look Concrete & Masonry Lacquer is ready to use. Do not thin. Use only when air (ambient) temperature is between 50-90°F (10-32°C) and the relative humidity is below 85% during the day and night. Do not apply in direct sunlight. Do not apply if rain is expected within 24 hours. Use in a well ventilated area.

Properties of Concrete & Masonry Lacquer

Manufacturer Rust-Oleum
Resin Type Acrylic
Pigment Type None
Solvent Acetone, Parachlorobenzotrifluoride, Xylene
Weight 3.78 Ltr.
Volatile Organic Compounds <400 g/l (3.3 lbs./gal.)
Practical Coverage at Recommended
200 sq.ft./gal. (single coat)
Actual coverage will vary depending
on the porosity of the surface
Dry Times at 70-80°F(21-27°C) and
50% RH
30 minutes to Touch
1-2 hours to Re-Coat
2 hours to Foot Traffic
72 hours to Full Care
Shelf Life 3 years
Flash Point -4°F (-20°C)
Safety Information For additional information, see MSDS
Technical Data Sheet Click here