Give commercial settings a long-lasting, attractive finish with Rust-Oleum Commercial C580 System 150 VOC General Purpose Latex. This low-odor, low-VOC formula is specially formulated to provide a high-hiding, uniform finish on interior walls and ceilings.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of the Product
- Excellent coverage and hide; makes touch-ups simple.
- Applies easily to properly primed wood, drywall, concrete and more.
- Durable formula—resists chipping, cracking, peeling and burnishing.
- Easy soap-and-water clean-up.
- Meets USDA requirements for incidental food contact; accepted for use in federally registered Canadian food facilities; VOC < 150 g/l.
How to Apply Commercial C580 System Latex Paint
Surfaces must be dry, clean and free of dirt, oil, grease, wax, dust, chalk, rust or any other contaminants that may prevent proper adhesion. Remove all loose or peeling paint. Glossy surfaces must be dulled by sanding. Patch all holes and cracks with appropriate patching compound and sand smooth. Plaster, concrete block, concrete and masonry surfaces must be cured. Remove all form release and curing agents. If the surface has a pH of 8 or higher, the surface must be primed with Zinsser Bulls Eye 1-2-3 Primer or an equivalent alkali resistant primer.
Mix thoroughly before use. Apply only when air, surface, and material temperatures are between 50-90°F (10-32°C), surface is at least 5°F above the dew point and relative humidity is below 85% during and after application. Apply by brush, roller, airless, HVLP or conventional spray. Flow and leveling is best achieved by applying a full, uniform coating and working to a wet edge using overlapping strokes. Do not brush or roll excessively.
Properties of Rust-Oleum Commercial C580 System Latex Paint
|Properties||Eggshell Finish||Semi-Gloss Finish|
|Weight||3.78 Ltr.||3.78 Ltr.|
|Resin Type||Ethylene Vinyl Acetate||Ethylene Vinyl Acetate|
|Pigment Type||Titanium dioxide and extenders||Titanium dioxide and extenders|
|Volatile Organic Compounds||<150 g/l (1.25 lbs./gal.)||<150 g/l (1.25 lbs./gal.)|
|Recommended Dry Film
Thickness (DFT) Per Coat
|1.0-2.0 mils (25-50µ)||1.0-2.0 mils (25-50µ)|
|Wet Film to Achieve DFT
|3.5-6.0 mils (87.5-150µ)||3.5-6.0 mils (87.5-150µ)|
|Practical Coverage at
Recommended DFT (assumes 15%
|190-435 sq.ft./gal. (4.7-10.7 m2/l)||190-435 sq.ft./gal. (4.7-10.7 m2/l)|
|Dry Times at 70°F
(21°C) and 50%
|1 hour to Touch.
4-6 hours to recoat.
|1 hour to Touch.
4-6 hours to Re-Coat
|Shelf Life||5 years||5 years|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|