251578 251578 Automotive

Rust-Oleum Automotive Shimmer Effect - Spray

Product Code: 251578

Availability:In stock

Rs. 710.00 710.00

Rust-Oleum Automative Shimmer Effect is designed to create a glitter effect over solid colors. It is recommended for automotive accessories, helmets, bikes and more. For best results, apply over dark colors.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of Automative Shimmer Effect Spray

  • Perfect for automotive and motorcycle accessories
  • Oil-based formula provides a durable, long-lasting finish, resists nicks and scratches
  • Shimmer finish, it dries in 20 minutes
  • 10-oz. can provides coverage up to 10 sq. ft.
  • Rust preventive for a long-lasting finish
  • For best results apply to darker colors
  • Clean up with mineral spirits

How to Apply Rust-Oleum Automative Shimmer Effect Spray

Surface Preparation

Plastic Surfaces: Remove all dirt, grease, and wax with Rust-Oleum Wax & Tar Remover. Wash the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and dry with a clean cloth. For best results, use Rust-Oleum Adhesion Promoter or sand surface with 100 grit sandpaper.

Metal Surfaces: Remove loose paint and rust with a wire brush or sandpaper. Thoroughly wipe down the surface with Rust-Oleum Wax & Tar Remover. Wash the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and dry with a clean cloth. For best results, use Rust-Oleum Adhesion Promoter or sand surface with 1000 grit sandpaper.

Application

Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-12"" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart. Maximum adhesiondevelops in 48 hours. Do not use near open flame.

Properties of Rust-Oleum Automative Shimmer Effect -Spray

Brand Rust-Oleum Automative
Manufacturer Rust-Oleum
Resin Type Acrylic Lacquer
Pigment Type Proprietary
Solvent Toluene and Xylene
MIR 1.40 Max
Fill Weight 10 ounces
Recommended Dry Film Thickness
(DFT) Per Coat
1.0-2.0 mils
(25-50µ)
Dry Times at 70-80°F
(21-27°C) and 50 RH
20 minutes to Touch
24 hours to Fully Dry
Anytime Re-Coat
Shelf Life 5 years
Flash Point -156°F (-104°C)