Rust-Oleum Automotive Rock Guard Spray is manufactured to protect the lower portion of vehicles from scratches, rocks, and debris. This peelable crystal clear coating is suitable for bumpers, trims, fenders, side mirrors and more. The best thing about rock guard crystal clear is it will remain transparent, won’t become yellow in sunlight. This is dry heat resistance up to 93°C.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Automotive Rock Guard Spray
- It will not become yellow in sunlight.
- Offer protection from scratches and harmful road debris.
NOTE: Primer is not required. This is ready to use.
Featured Video of Rust-Oleum Rock Guard Trim Spray Application
How to Apply Rust-Oleum Rock Guard Paint?
Ideal Conditions to Spray
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10- 32°C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C) or galvanized metal. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Wash the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and dry with a clean cloth. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 8-10" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply 4 or more light coats to build desired coating thickness, followed by one medium coat to achieve a smooth final film. Allow the coating to dry slightly (about 2-3 minutes) between coats. More coats will result in a thicker coating which is easier to remove when desired. Allow the coating to cure for 24 hours before washing. Do not use near open flame.
Properties of Rust-Oleum Rock Guard Spray Paint
|Resin Type||Styrene Blocked Copolymer|
|Solvents||Acetone, Aliphatic Hydrocarbons, Xylene|
Recommended Dry Film
Thickness (DFT) Per Coat
|0.5-1.0 mils (12.5-25µ)|
at Recommended DFT
Dry Times at 70-80°F
(21-27°C) and 50% Relative Humidity
|20 minutes to touch and re-coat after 20 minutes|
|Dry Heat Resistance||200°F (93°C)|
|Shelf Life||2 years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|