Rust-Oleum High Performance Wheel Spray Paint | Alloy Wheel Paint
Rust-Oleum High Performance Wheel Spray Paint - Steel - 312 Grams
Rust-Oleum High Performance Wheel Spray Paint - Matte Black - 312 Grams
Rust-Oleum High Performance Wheel Spray Paint - Clear - 312 Grams
Rust-Oleum High Performance Wheel Spray Paint - Graphite - 312 Grams

Rust-Oleum High Performance Wheel Spray Paint | Alloy Wheel Paint

Regular price Rs. 620.00 Sale

Rust-Oleum High Performance Wheel and Rim Spray Paint enables you to customize the wheel/rim of car and bike. This rust preventive aerosol can be sprayed over plastic, hubcaps, aluminium or steel. High Performance Wheel features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.

Features of High Performance Wheel Spray Paint

  • Gives Standout appearance
  • Resistant to water
  • Best to use for wheels such as plastic hubcaps, steel, aluminium etc.
  • Available in clear, matte black, steel, and graphite.

NOTE: To achieve glossier finish, top with clear.

Featured Video of Rust-Oleum Wheel Paint Application



How to Apply Rust-Oleum High Performance Rim Spray Paint?

Suitable Environmental Conditions

Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10-32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C) or galvanized metal. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.

Surface Preparation

Wash the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and dry with a clean cloth. Thoroughly wipe down the wheel surface with Rust-Oleum Wax & Tar Remover. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand smooth and glossy surfaces. For best results, use Rust-Oleum Adhesion Promoter or sand surface with #1000 grit sandpaper.

Application

Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16"" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can in motion while spraying. For best appearance, apply one light coat followed by one wet coat. Do not use near open flame.

Properties of Rust-Oleum High Performance Wheel Spray Paint


Brand Rust-Oleum
Weight 312 Grams
Recommended Dry Film
Thickness (DFT) per Coat
1.0-2.0 mils (25-50µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
8-10 sq. ft./can
Dry Times at 70-80F
(21-27°C) and 50% Relative Humidity
10 min to touch, 10 min to re-coat and 30 min to fully dry
Resin Type Acrylic
Pigment Type Proprietary
Solvents Acetone, Toluene, Xylene
MIR 1.40 Max
Flash Point -156°F (-104°C)
Shelf Life 5 Years
Safety Information For additional information, see MSDS
Technical Data Sheet Click here