Rust-Oleum Professional Grade Truck Bed Coating Aerosol provides a textured, non-skid surface which offers excellent durability, abrasion resistance and excellent adhesion. Professional Grade Truck Bed Coating can be applied directly to bare metal. It provides a barrier to rust and offers excellent impact, fade and chip resistance.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of the product
- Professional Grade formula.
- Fade, chip & impact resistant.
- Textured, non skid finish formulated for durability.
- Paint & Primer in one.
- High output tip delivers an even finish.
- No Peel Promise, adhesion guarantee.
NOTE: Hold can 18-24" from the surface & spray in a rapid, steady back & forth motion.
How to Apply Truck Bed Coating Aerosol?
Suitable Conditions To Spray
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10- 32°C) and humidity is below 85% to ensure proper drying. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Remove all rust, oil and grease from surfaces to be coated. Surface must be clean and dry. Painted surfaces must be sanded with medium grit sandpaper prior to painting. Remove all sanding dust with a clean cloth. Protect and mask off all surrounding areas to prevent overspray on auto finish. Apply to bare or primed metal surface.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 18-24" from surface and spray in a rapid steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Remove any overspray from the auto finish immediately. For best results, apply 2-3 coats. Allow coating to dry 20-30 minutes between coats. Do not use near open flame.
Properties of Truck Bed Coating Aerosol
|Recommended Dry Film
Thickness (DFT) per Coat
|3.0-4.0 mils (75-100µ)|
|Practical Coverage at Recommended
DFT (assumes 15% material loss)
|7.0 sq. ft./can|
|Dry Times at 70-80F
(21-27°C) and 50% Relative Humidity
|1 hour to track-free and 30 minutes to re-coat|
|Resin Type||Synthetic Rubber|
|Pigment Type||Carbon Black|
|Solvents||Acetone, Methyl Amyl Ketone, N-butyl Acetate, Xylene, VM&P Naphtha|
|Flash Point||-156°F (-104°C)|
|Shelf Life||5 Years|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|