Rust-Oleum Automotive Lens Tint Spray Paint for Tail Lights
Product Code: 253256
Availability:Out of stock
Have a question?
Rust-Oleum Lens Tint Spray Paint is a translucent coating that is designed to give your vehicle a customized appearance. When applied, Lens Tint gives your lights a tinted appearance until they are lit. When illuminated the natural color shows through. Lens tint is ideal for tail lights, fog lights, side markers, or turn indicators and is recommended for off road use. Rust-Oleum Lens Tint features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Lens Tint Spray
- Creates a “black out” appearance on tail lights.
- When lights are engaged the natural color shows through.
- Recommended for off road use only.
- Any-angle spray technology.
- Comfort-tip spray nozzle.
NOTE: Don’t apply more than 3 coats.
Featured Video of Rust-Oleum Lens Tint Spray Paint Application
How to Apply Lens Tint Spray Paint?
Suitable Conditions To Spray
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50°F (10°C) and 90°F (32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Surface Preparation
Removing the lens from your vehicle is recommended for ease of application. If you cannot remove the lens from your vehicle, mask adjoining areas to protect from spray mist. Prepare the surface by removing any oil, grease, wax, or road tar. For best results use a clean cloth and wipe the surface with Rust-Oleum Wax and Tar Remover.
Application
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can in motion while spraying. Apply one light coat or just enough to change the lens color. DO NOT exceed three coats or light may not show through. Do not use near open flame.
Properties of Rust-Oleum Lens Tint Spray Paint
Brand | Rust-Oleum |
---|---|
Weight | 283 Grams |
Recommended Dry Film Thickness (DFT) per Coat |
1.0-2.0 mils (25-50µ) |
Practical Coverage at Recommended DFT (assumes 15% material loss) |
8-10 sq. ft./can |
Dry Times at 70-80F (21-27°C) and 50% Relative Humidity |
20 min to touch and re-coat with in 1 hour or after 24 hours |
Resin Type | Modified Alkyd |
Pigment Type | Proprietary |
Solvents | Acetone and Aromatic Hydrocarbons |
MIR | 1.40 Max |
Flash Point | -156°F (-104°C) |
Shelf Life | 5 Years |
Safety Information | For additional information, see MSDS |
Technical Data Sheet | Click here |