Rust-Oleum Automotive Sandable Black Primer Paint - Brush On

Rust-Oleum Automotive Sandable Black Primer Paint - Brush On

Regular price Rs. 3,050.00 Sale

Rust-Oleum Sandable Primer is designed to provide a tough, rust-inhibitive base for most brands of automotive lacquers, enamels, and finishes. It is ideal for use on metal, wood, and fiberglass surfaces and is especially recommended for sandable automotive refinishing.

Features of the primer paint

  • All Purpose.
  • Stops Rust formula.
  • Wet and Dry Sandable.

NOTE: Strain Sandable Primer with a fine screen before pouring it into the spraygun cup.

How to Apply Automotive Sandable Primer Paint

Suitable Enviornmental Conditions

Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50°F and 90°F (10-32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C) such as mufflers and exhaust components.

Make The Surface Suitable

Clean the surface with a mild ammonia based cleaner and warm water. Rinse and then dry with a clean lint-free cloth. Remove loose paint, dirt and rust with a wire brush or sandpaper. Wipe the entire area with Rust-Oleum Wax & Tar Remover and a clean lint-free cloth to remove any dirt, grease, wax etc. Scuff-sand and feather edge the entire surface with 1,000 grit sandpaper, Scotch Brite pad or equivalent. Use a tack cloth to remove any sanding dust or particles. Mask surrounding areas to protect from overspray.


Mix thoroughly to ensure any settled pigment is redispersed. Strain Sandable Primer with a fine screen before pouring it into the spray gun cup. Set conventional spray gun pressure to 30-40 psi. Apply 2-3 coats allowing 5-10 minutes of dry time between coats. For best results allow Primer to dry for 1 hour before dry sanding. Test in an inconspicuous area to be sure Primer is dry enough for sanding. Block sand the area using 320-400 grit sandpaper. Do not use near open flame.

Properties of Rust-Oleum Sandable Primer Paint


Brand Rust-Oleum
Resin Type Proprietary
Pigment Type Carbon Black and Inert Pigments
Solvents Acetone, Methyl Acetate, 2-Ethoxyethyl Acetate
Practical Coverage
at Recommended DFT
40-50 sq. ft./quart (1.0-1.2 m2 /quart)
Fill Weight 946 ml
Recommended Dry Film
Thickness (DFT) Per Coat
1.0 mil (25µ)
Dry Times at 70-80°F
(21-27°C) and 50% Relative Humidity
20 to 30 minutes to touch and re-coat after 1 hour
Shelf Life 5 years
Flash Point -4°F (-20°C)
Safety Information For additional information, see MSDS
Technical Data Sheet Click here