Rust-Oleum Automotive Rust Metal Primer Spray prepares rusty metallic surfaces for paint application. It offers excellent rust prevention when top-coated with automotive lacquer spray paint or enamel spray paint. Rusty Metal Primer features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying. It is possible to spray 10-12 square feet of area with one cane.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Rusty Metal Primer
- Serve the best base-coat on heavily rusted metal.
- Made with stops rust formula.
- Wet and dry.
- Fast drying.
- Serve the utmost protection with Rust-Oleum top coat.
How to apply Rust-Oleum Rusty Metal Primer Spray?
How to Apply Rusty Metal Primer Spray?
Suitable Environmental Conditons
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10- 32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C) or galvanized metal. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Wash the surface with a commercial detergent, or other suitable cleaning method to remove dirt. Rinse with fresh water and dry with a clean cloth. Remove all oil, grease, wax and petroleum based materials with mineral spirits. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 12-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply 2 or more light coats a few minutes apart. Apply multiple light coats versus applying one heavy coat. Do not use near open flame.
Properties of Rust-Oleum Rusty Metal Primer Spray
|Resin Type||Modified Alkyd|
|Pigment Type||Inorganic Oxides|
|Solvents||Acetone and Aromatic Hydrocarbons|
|Fill Weight||340 Grams|
|Recommended Dry Film
Thickness (DFT) Per Coat
|1.5-2.5 mils (37.5-62.5µ)|
|Practical Coverage at Recommended DFT||10-12 sq.ft./can|
Dry Times at 70-80°F
(21-27°C) and 50% Relative Humidity
|10-15 minutes to touch and re-coat within 1 hour|
|Dry Heat Resistance||200°F (93°C)|
|Shelf Life||5 Years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|