Rust-Oleum Automotive Primer Spray - Adhesion Promoter

Rust-Oleum Automotive Primer Spray - Adhesion Promoter

Regular price Rs. 650.00 Sale

Rust-Oleum Automotive Primer Adhesion Promoter is a fast drying, clear primer to promote adhesion to polyolefin surfaces such as automotive plastics, vinyl, trim, bumpers, fiberglass, and more. Rust-Oleum Adhesion Promoter features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.

Features of Automotive Primer

  • Bonds topcoats to vinyl, plastic, fiberglass and more.
  • Adhesion Promoter features an advanced spray system that allows you to spray at any angle.
  • A comfort spray tip with wider finger pad.

NOTE: A top coat must be applied within 10 minutes of the final coat of Adhesion Promoter.

How to Apply Automotive Primer Spray to Promote Adhesion?

Ideal Environmental Conditions

Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50°F and 90°F (10-32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.

Surface Preparation

Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Clean area to be primed with mineral spirits to remove all oil, grease, wax, and dirt. Remove loose paint with a wire brush or sandpaper. Lightly sand glossy surfaces. Wipe the sanded surface clean when finished.

Application

Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 12-16" from the surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. For best results, apply 2 or more light coats a few minutes apart. Do not use near open flame.

Properties of Automotive Primer - Adhesion Promoter Spray

Brand Rust-Oleum
Resin Type Chlorinated polyolefin
MIR 2.50 Max
Fill Weight 312 Grams
Recommended Dry Film
Thickness (DFT) Per Coat
1.0-1.5 mils (20-37.5µ)
Practical Coverage at Recommended DFT 10-12 sq.ft./can
Dry Times at 70-80°F
(21-27°C) and 50% Relative Humidity
10 minutes to touch and re-coat any time after 10 minutes
Shelf Life 5 Years
Flash Point -156°F (-104°C)
Safety Information For additional information, see MSDS
Technical Data Sheet Click here