Rust-Oleum Automotive Primer Spray Paint for Plastic
Product Code: 249323
Availability:Out of stock
Have a question?
Rust-Oleum Plastic Primer Spray is designed to prepare interior and exterior plastic surfaces for painting with most brands of automotive lacquers and enamels. For maximum protection, top coat with Rust-Oleum Rust Preventive Auto Paint. If using an auto lacquer, a test application for compatibility is recommended. Plastic Primer features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of the plastic primer spray
- For ultimate adhesion on plastic surfaces.
- Any-Angle Spray with Comfort Tip.
- For maximum protection, top coat with Rust-Oleum finishes.
NOTE: if using an auto lacquer, a test application for compatibility is required.
How to use Plastic Primer Spray?
Suitable Enviornmental Conditions
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10- 32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C) or galvanized metal. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Make Your Surface Ideal
Remove all dirt, oil, grease, wax and petroleum based materials with mineral spirits. Allow the surface to dry thoroughly.
Application of Primer
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 12-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. For best adhesion, apply ONE thin coat. Do not apply a heavy coat or multiple coats of Auto Plastic Primer. Do not use near open flame.
Properties of Plastic Primer Spray
Brand | Rust-Oleum |
---|---|
Resin Type | Modified Alkyd |
Pigment Type | Titanium Dioxide |
Solvents | Acetone and Toluene |
MIR | 1.20 Max |
Fill Weight | 340 Grams |
Recommended Dry Film Thickness (DFT) Per Coat |
1.5-2.5 mils (37.5-62.5µ) |
Practical Coverage at Recommended DFT | 10-12 sq.ft./can |
Dry Times at 70-80°F (21-27°C) and 50% Relative Humidity |
20 minutes to touch 1 hour to re-coat |
Dry Heat Resistance | 200°F (93°C) |
Shelf Life | 5 Years |
Flash Point | 156°F (-104°C) |
Safety Information | For additional information, see MSDS |
Technical Data Sheet | Click here |