263422 263422 Automotive

Rust-Oleum Automotive Matte Black Spray Paint for Motorcycle and Car

Product Code: 263422

Availability:Out of stock

Rust-Oleum Automotive Matte Finish provides a low profile, non-reflective finish that is fast drying and has excellent coverage. This durable formula can be applied over bare and primed metal surfaces for a smooth matte finish. This finish is ideal for use on autos, trailers, RVs and auto accessories. Matte Finish features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of Matte Black Spray Paint

  • Any angle spray with comfort tip.
  • Trusted Stops Rust technology.
  • Fast Drying.
  • It is possible to cover 15 sq.ft. with one can.

NOTE: Do not apply to surfaces that exceed 93°C.

How to Apply Matte Black Spray Paint?

Appropriate Conditions to Spray

Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90ºF (10-32ºC) and humidity is below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200ºF (93ºC). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.

Surface Preparation

Clean with soap and water, rinse and let dry. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces.

Priming For Best Results

Use of a Rust-Oleum Primer provides added corrosion protection on metal and promotes adhesion and hiding. A primer is especially recommended for heavily rusted or pitted surfaces. Recommended sandable primer spray include 249419 Red, 252472 Light Gray or 249415 Gray.


Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16” from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart. Apply multiple coats versus applying one heavy coat. Do not use near open flame. DRY & RECOAT.

Properties of Matte Black Spray Paint

Brand Rust-Oleum
Resin Type Modified Alkyd
Pigment Type Amorphous Silica, Carbon Black, Black Iron Oxide
Solvents Acetone and Aromatic Hydrocarbons
Weight 312 Grams
Recommended Dry Film
Thickness (DFT) Per Coat
1.0-2.0 mils (25-50µ)
Practical Coverage 
at Recommended DFT
15 sq.ft./can
Dry Times at 70-80°F 
(21-27°C) and 50% Relative Humidity
20 minutes to touch and 24 hours to fully dry
Shelf Life 5 years
Flash Point -156ºF (-104ºC)
Safety Information For additional information, see MSDS
Technical Data Sheet Click here