Rust-Oleum Automotive Filler Primer Spray is being used to fill the minor imperfection in surfaces such as wood, metal and fiberglass. It improves topcoat adhesion and appearance. 10-12 square feet of area can be covered with one spray cane. Filler Primer features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of Filler Primer Spray:-

Hi-build formula.
Fills in imperfections.
For use on metal, wood and fiberglass surfaces.
Stops Rust formula.
Available in aerosol and brush on.

How to Apply Rust-Oleum Automotive Filler Primer Spray?

Ideal Conditions to Spray

Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10- 32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C) or galvanized metal. Avoid spraying in very windy and dusty conditions Cover surrounding area to protect from spray mist.

Surface Preparation

Wash the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and dry with a clean cloth. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces.

Application

Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 12-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply 2 or more light coats a few minutes apart. Do not use near open flame.

Properties of Rust-Oleum Automotive Filler Primer Spray

Brand	Rust-Oleum
Weight	312 Grams
Recommended Dry Film Thickness (DFT) per Coat	1.5-2.5 mils (37.5-62.5µ)
Practical Coverage at Recommended DFT (assumes 15% material loss)	10-12 sq.ft./can
Dry Times at 70-80°F (21-27°C) and 50% Relative Humidity	10 minutes to touch and re-coat any time after 10 minutes
Resin Type	Modified Alkyd
Pigment Type	Titanium Dioxide and Inorganic Pigments
Solvents	Acetone and Aromatic Hydrocarbons
Dry Heat Resistance	200°F (93°C)
Shelf Life	5 Years
Flash Point	-156°F (-104°C)
Safety Information	For additional information, see MSDS
Technical Data Sheet	Click here

Rust-Oleum Automotive Filler Primer Spray

Have a question?