249319 249319 Automotive

Rustoleum Automotive Clean Metal Primer Spray - White Metal Primer

Product Code: 249319

Availability:Out of stock

Rust-Oleum Automotive Clean Metal Primer Spray is designed to prepare the surface of clean, lightly rusted or previously painted metal for application of automotive lacquers and enamels. Clean Metal Primer provides excellent rust prevention when top coated with lacquers or automotive enamels. For best results, top coat with Rust-Oleum Auto Paint. If using an auto lacquer, a test application for compatibility is recommended. Clean Metal Primer features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of the Clean Metal Primer Spray

    • Bonds right to metal.
    • Provides superb adhesion.
    • Stops Rust formula.
    • Any-Angle Spray with Comfort Tip.

NOTE: Use outdoors or in a well-ventilated area such as an open garage.

How to Apply Automotive Clean Metal Primer?

Appropriate Environmental Conditions

Use outdoors or in a well ventilated area such as an open garage.Use when temperature is between 50-90°F (10- 32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C) or galvanized metal.Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.

Surface Preparation

Wash the surface with a commercial detergent, or other suitable cleaning method to remove dirt.Rinse with fresh water and dry with a clean cloth. Remove all oil, grease, wax and petroleum based materials with mineral spirits.Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces.


Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 10-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply 2 or more light coats a few minutes apart. Do not use near open flame.

Properties of Clean Metal Primer Spray

Brand Rust-Oleum
Resin Type Modified Alkyd
Pigment Type Titanium Dioxide
Solvents Acetone and Aromatic Hydrocarbons
MIR 1.20 Max
Fill Weight 340 Grams
Recommended Dry Film
Thickness (DFT) Per Coat
1.5-2.5 mils (37.5-62.5µ)
Practical Coverage at Recommended DFT 10-12 sq.ft./can
Dry Times at 70-80°F
(21-27°C) and 50% Relative Humidity
15 to 30 minutes to touch and re-coat within an hour or after 48 hours
Dry Heat Resistance 200°F (93°C)
Shelf Life 5 Years
Flash Point -156°F (-104°C)
Safety Information For additional information, see MSDS
Technical Data Sheet Click here