Rust-Oleum Watertite Hydraulic Waterproof Cement
Product Code: 5071
Availability:Out of stock
Have a question?
Is your terrace leaking? Is there any water leakage in your basement? No more worries because Rust-Oleum Watertite Hydraulic Cement is available in India now! This waterproof cement stops water flow seal deep cracks and holes enduringly. This specialty which makes it special from other products is, it creates a watertight seal within 5 minutes even when water is flowing. It can be used for all grades of concrete including block, cast-in-place concrete, slump block, and more. It can be used for bricks as well. This is the best hydraulic cement for waterproofing of roofs, basement, foundations, walls etc. This product is also suitable to use on fountains, planters, door, and more.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Hydraulic Waterproof Cement
- Creates watertight barrier in flowing water.
- Best to seal cracks on roofs, basement, and walls.
- Works will all grades of concrete.
- Works on wet surfaces.
Alert: Sets very fast! So mix as much as you can use within 3 to 5 minutes.
How to Use Rust-Oleum Zinsser Hydraulic Waterproof Cement?
Surface Preparation
Important : Wear eye protection and rubber gloves when working with WaterTite Hydraulic Cement. Chisel holes to enlarge them by at least ¼” and scrape clean. Remove any loose or chipped concrete. Make sure the surface to be patched is damp.
Application
Mix two parts WaterTite Hydraulic Cement to one part of water. Stir the mixture until it reaches a putty-like paste. Mixture will begin to set in 3 to 5 minutes. Only mix as much material as you can use at one time. Hold mixture compound in gloved hand until it becomes warm. Force it firmly into the hole or crack and hold in place for 5 minutes. Immediately trim or brush away any excess cement for a smooth finish.
Properties of Rust-Oleum Watertite Hydraulic Waterproof Cement
Brand | Rust-Oleum |
---|---|
Manufacturer | Rust-Oleum |
Composition | Portland Cement, Alumina, Crystalline Silic |
Solvents | None |
Weight | 4.5 Kg |
Volatile Organic Compounds | NA |
Practical Coverage at Recommended DFT (assume 15% material loss) |
137-523 sq. ft./gal. (3.4-13.4 m2/l) |
Dry Times at 70-80° (21-27°C) and 50% RH |
3 to 5 minutes to Working Time 5 minutes to Setting Time 28 days to Final Cure |
Shelf Life | 2 years |
Flash Point | NA |
Safety Information | For additional information, see MSDS |
Technical Data Sheet | Click here |