Use our Rustoleum Specialty Magnetic Primer when it comes create a wall that attract magnetics. The application of this paint is not just limited to drywall only, you can use it for wood, metal, masonry, and other surfaces as well. Nowadays, people prefer magnetic paint to hang notices, photos, and reminder notes; instead of using notice boards because notice boards not safe at all. You can also enhance the appearance of your rooms, if walls are treated with this primer, by hang photos or wallpapers. Now, Rustoleum Magnetic primer is available with 3x stronger formula so you can easily top coat with any latex or even chalkboard paint.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Rustoleum Magnetic Primer Paint
- Safe to use for kids’ class room.
- It can be applied on multiple surfaces.
- Safe to use near electronics.
- You can top coat this any latex or chalkboard paint.
Best practice: Stir the paint for 10 minutes at least to get optimum results.
Instructions to Use Rustoleum Magnetic Primer
Appropriate Conditions: Apply when temperature is between 50-90°F (10-32°C) and humidity is below 85% to ensure proper drying. Before beginning the project, tape around the area you wish to paint. Wear gloves to prevent skin contact.
Surface Preparation: Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces. Clean with soap and water, rinse and let dry. WARNING! If you scrape, sand or remove old paint, you may release lead dust.
Application: Mix thoroughly to ensure any settled pigment is re-dispersed. Thinning is not required. Stir thoroughly regularly during application. Use a foam roller designed to give a smooth finish. Apply the primer with an up and down motion and work the area to give the smoothest finish. A smooth uniform surface will provide for stronger magnetic attraction. Apply entire quart to 16 square foot area.
Properties of Specialty Magnetic Primer Paint
|Resin Type||Modified Alkyd|
|Solvents||Mineral Spirits, Glycol Ether|
|Recommended Dry Film Thickness
(DFT) per Coat
|4.0-5.0 mils (100-125µ)|
|Practical Coverage at Recommended
DFT (assumes 15% material loss)
|39-48 sq.ft./quart (1 coat)|
|Dry Times at 70-80°F (21-27°C)
and 50% Relative Humidity
|30 minutes to touch and re-coat|
|Shelf Life||5 years|
|Flash Point||>200°F (93°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|