Rust-Oleum Specialty Lacquer Spray Paint is a protective coating which is available in clear. This aerosol spray is manufactured to deliver protection and clear luster finish. This paint provides excellent protection to wood, metal, plaster and more from scratches. This can be used for furniture, lamps, picture frames etc. This fast drying paint gets dried in 20-30 minutes. This acrylic based formula is compatible with interior and exterior environment.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Lacquer Gloss Clear Spray Paint
- Suitable for multiple surface.
- Ideal for interiors and exteriors.
- Delivers transparent luster.
- Fast drying.
NOTE: Prepare the glossy surface before application.
How to Use Specialty Lacquer Gloss Clear Spray Paint?
Suitable Environment Conditions to Use
Use outdoors or in a well ventilated area. Use when temperature is between 50-90°F (10-32°C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces.
Spraying / Application
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Hold can upright 10-16" from surface and spray in a steady back and forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply two or more light coats a few minutes apart to avoid drips and runs. Do not use near open flame.
Properties of Lacquer Gloss Clear Spray Paint
|Resin Type||Acrylic Lacquer|
|Solvents||Acetone, Methyl Ethyl Ketone, Toluene|
|Practical Coverage at Recommended
DFT (assumes 15% material loss)
|Approximately 7 sq.ft./can|
|Dry Times at 70-80°F (21-27°C)
and 50% Relative Humidity
|20 minutes to touch, fully dry in 30 minuets|
|Dry Heat Resistance||200°F (93°C)|
|Shelf Life||5 years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|