1932830 1932830 Specialty

Rust-Oleum Specialty Fluorescent Spray Paint

Product Code: 1932830

Availability:In stock

Rs. 780.00 Rs. 702.00 702.00

Available Options

Truworth Homes brings highly visible Rustoleum Fluorescent Spray Paints that are available in green, orange, yellow, pink and red-orange colors. These aerosol spray are very useful when it is needed to grab someone’s attentions, means these are ideal for marking. These paints also can be used for art and craft purposes such as for decorating toys, walls, stenciling, and more. This product is suitable for using over wood, metal, plastic etc. In order to obtain best results, it is suggested to spray it over white basecoat. As per the technical data sheet from the manufacturer, its cover is 10-12 square feet per spray cane. NOTE: This is fluorescent spray paint, this is not glow in the dark paint.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of Fluorescent Spray Paint

  • Interior/Exterior Durability.
  • Economical to use.
  • Suitable for numerous surface.
  • Paint glows under UV light.

NOTE: For best results, read manufacturers guidelines.

How to Apply Rustoleum Fluorescent Spray Paint?

Prepare Your Surface

Surface preparation plays a vital role for paint adhesion and durability. Therefore, prepare the surface by removing all the dirt, grease, oil, salt and other chemical contaminants. If surface is already painted and you’ve loose paint then it is suggested to remove that via wire brush or sandpaper. Once surface is cleaned, wash that with water and leave that to dry. If you are going to apply fluorescent spray over glossy surface like plastic then create surface profile by light sanding. Don’t use this product on galvanized steel.

Suitable Atmospheric Conditions to Paint

It is very important to consider atmosphere for getting best results. Before spraying, always make sure that temperature is between 10-32°C and humidity is below 85%. You would be needing proper ventilation while spraying therefore choose well-ventilated area to spray. If the temperature of the surface is more than 93°C then don’t apply. Also, it is not good to use aerosol spray in windy and dusty conditions, therefore avoid to spray if you found the same. Don’t apply near open flame.

Application of Paint

Jiggle your aerosol cane properly before spraying. Hold can upright 10-16" from surface and spray in a steady back and forth motion, slightly overlapping each stroke. Maintain the distance between spray cane and surface while spraying. Remember, cane should be in the motion during use. Apply two or more light coats a few minutes apart to avoid drips and runs.

Properties of Rust-Oleum Specialty Fluorescent Spray Paint

Manufacturer Rust-Oleum
Resin Type Modified Acrylic Lacquer
Pigment Type Varies with color
Solvents Acetone, Hexane, Toluene, Xylene
Weight 312 Grams
Practical Coverage at Recommended
DFT (assumes 15% material loss)
Approximately 10-12 sq.ft./can
Dry Times at 70-80ºF
(21-27ºC) and 50%
Relative Humidity
15 minutes and re-coat any-time
Dry Heat Resistance 200°F (93°C)
Shelf Life 5 years
Flash Point >-156°F (-104°C)
Safety Information For additional information, see MSDS
Technical Data Sheet Click here