267028 267028 Specialty

Rust-Oleum Specialty Clear Matte Finish Spray Paint

Product Code: 267028

Availability:Out of stock

Rust-Oleum Specialty Clear Matte Finish Spray Paint is manufactured to eliminate the glossiness of surface. This aerosol spray can be used for wood, metal, plastic, glass wicker, paper, ceramic, and other surface. This acrylic based formula is ideal to protect decorative projects from stains, just spray and protect! This crystal clear coating will remain transparent, this will not change into yellowish finish. The coverage of clear matte finish spray is 8-10 square feet per cane.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of Clear Matte Finish Spray

  • Eliminates gloss and glare.
  • Perfect for preserving kids arts and crafts projects.
  • Non-yellowing.
  • Fast drying.
  • Good Coverage.

NOTE: For best results, use painters touch primer spray when you are using this product for bare wood and metal.

Featured Video of Clear Matte Finish Spray Paint

How to Use Rust-Oleum Clear Matte Finish Spray Paint?

Appropriate Conditions to Spray

Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90ºF (10-32ºC) and humidity is below 65% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C), or galvanized steel. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.

Surface Preparation

Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces to create a surface profile.

Application / Spraying

Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 6-8” from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply two or more light coats a few minutes apart. Do not use near open flame.

Properties of Rust-Oleum Clear Matte Finish Spray Paint

Manufacturer Rust-Oleum
Resin Type Acrylic
Pigment Type NA
Solvents Acetone, Toluene, Xylene
Weight 312 Grams
Practical Coverage at Recommended
DFT (assumes 15% material loss)
8-10 sq.ft./can.
Dry Times at 70-80°F (21-27°C)
and 50% Relative Humidity
5 minutes to touch and 24 hours to fully dry
Shelf Life 5 years
Flash Point -156°F (-104°C)
Safety Information For additional information, see MSDS
Technical Data Sheet Click here