Rust-Oleum Stops Rust Satin Enamel Spray Paint
Product Code: 7720830
Have a question?
Rust-Oleum Stops Rust Satin Enamel Spray Paint a classic low sheen finish for interior and exterior projects. These are perfect to paint furniture, for decoration, and for many other countless uses. This oil modified alkyd satin enamel sprays offer superior coverage up to 10-12 square feet. Some qualities which makes them stand out from others are these are resistance to rust, fading, chipping, dulling, and abrasion. These are dry heat resistance up to 93°C.
Features of Satin Enamel Spray Paint
- Suitable for interior and exterior.
- Dry heat resistance up to 93°C.
- Superior coverage.
- Resistance to rust, fading, chipping, dulling and abrasion.
NOTE: This products is not suitable for galvanized steel.
Featured Video of Rust-Oleum Stops Rust Satin Enamel Touch Up Spray Paint
How to Use Rust-Oleum Stops Rust Satin Enamel Spray Paint?
Suitable Conditions to Use
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10-32°C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C). Do not apply to galvanized steel. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16" from surface and spray in a steady back-andforth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply two or more light coats a few minutes apart to avoid drips and runs. Do not use near open flame.
Properties of Rust-Oleum Stops Rust Satin Enamel Spray Paint
|Resin Type||Oil Modified alkyd|
|Pigment Type||Varies with color|
|Solvents||Acetone, Aromatic Hydrocarbons, Xylene|
Recommended Dry Film
Thickness (DFT) Per Coat
|1.0-2.0 mils (25-50µ)|
at Recommended DFT
|10-12 sq. ft./can|
|Dry Times at 70-80°F (21-27°C)
and 50% Relative Humidity
|2-4 hours to touch and re-coat before 1 hour or after 24 hours|
|Dry Heat Resistance||200°F (93°C)|
|Shelf Life||5 years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|