Rust-Oleum Stops Rust Anti-Slip Slip Resistant Coating Spray
Product Code: 271455
Have a question?
Rust-Oleum Stops Rust Anti-Slip creates a non-skid surface on concrete, metal and wood. The fast drying formula dries clear and can be applied to ramps, stairs, railings and more.
Stops Rust Anti-Slip features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
Features of Stops Rust Anti-Slip Slip Resistance Coating Spray
- Slip resistant coating
- Great for steps, decks, porches, walkways, garage floors, ramps, tile floors and more
- Clear finish
- For indoor and outdoor use
How to Apply Stops Rust Anti-Slip Slip Resistance Coating Spray
Wash the surface with a commercial detergent, or other suitable cleaning method to remove dirt. Rinse with fresh water and let dry. Remove loose paint and rust with a wire brush or sandpaper. Clean concrete surfaces with a suitable cleaner and water. Rinse and allow to dry. Lightly sand glossy surfaces.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 12-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply 2 or more light coats a few minutes apart. Do not use near open flame.
Properties of Stops Rust Anti-Slip Slip Resistant Coating Spray
|Brand||Rust-Oleum Stops Rust|
|Resin Type||Proprietary Non-Hazardous Polymer|
|Solvents||Acetone, Ethyl Benzene, N-Butyl Acetate, Xylene|
|Fill Weight||12 ounces|
|Recommended Dry Film
Thickness (DFT) Per Coat
|1.5-2.5 mils (37.5-62.5µ)|
|Practical Coverage at Recommended
DFT (assume 15% material loss)
|Dry Times at 70-80°F
(21-27°C) and 50% RH
|2-4 hours to Touch
Apply a second coat within 1 hour or after 48 hours to Re-Coat
Allow surfaces to dry for 24 hours before use to Fully Dry
|Dry Heat Resistance||200°F (93°C)|
|Shelf Life||5 years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|