Rust-Oleum Frosted Glass Spray is an innovative semi-transparent coating which creates etching like effect. This spray is amazing for interior decoration. You can use it with stencil to make custom designs over glass, mirrors and more. The coverage of this spray is 7 square feet (assuming 15% of material loss). This spray paint takes 5-10 minutes to dry so that you can complete your job in a short period of time.
Features of Frosted Glass Spray
- Delivers etched glass look to shower doors, windows, mirrors etc.
- Tough acrylic resin.
- Fast drying.
- Ideal for decoration.
NOTE: This is not recommended to exteriors.
Featured Video of Rust-Oleum Frosted Glass Spray
How to Use Rust-Oleum Frosted Glass Spray?
Ideal Conditions to Spray
Use outdoors or in a well ventilated area. Use when temperature is between 50-90°F (10-32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C) or surfaces that are exposed to repeated or continuous water contact, such as the inside of shower doors. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry.
Application / Spraying
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Hold can upright 10-16" from surface and spray in a steady back and forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply two or more wet coats a few minutes apart for best appearance. A wet coat should appear shiny as it is applied to the surfaces. WAIT 10 MINUTES FOR FROST EFFECT. Not for outdoor use. Do not use nearopen flame
Properties of Rust-Oleum Specialty Frosted Glass Spray
|Resin Type||Acrylic Lacquer|
|Solvents||Acetone, N-Butyl Acetate, Xylene|
|Practical Coverage at Recommended
DFT (assumes 15% material loss)
|Approximately 7 sq.ft./can|
|Dry Times at 70-80°F (21-27°C)
and 50% Relative Humidity
|5 minutes to touch, fully dry in 10 minuets,
and re-coat any-time
|Dry Heat Resistance||200°F (93°C)|
|Shelf Life||5 years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|